Токарные инструменты Iscar (часть 1) 2026 - страница 585

PARTING OAH OAW A-A A-A TGTBY-JHP HTPRM Bar Max Y-Axis Intermediate Prismatic LF CUTDIA Holders for Square JHP OAL Adapters on Multi-Task Machines LB for Parting and Grooving HF TGTBY R32-D82R-JHP with TGAQ Shown Designation OAH HF OAW LF LB CUTDIA OAL(1) HTPRM OAL_2(2) TGTBY R/L32-D82R-JHP 42.00 65.8 16.00 150.00 62.00 82.0 153.00 32.00 156.40 TGTBY R/L32-D82L-JHP 42.00 65.8 16.00 150.00 62.00 82.0 153.00 32.00 156.40 • Can be used also for X-axis (multi-task machines) - location pin should beremoved (1) Overall length with TGAQ adapter (2) Overall length with DGAQ adapter For tools, see pages: DGAQ (580) • DGAQ-JHP (580) • TGAQ (579) • TGAQ-JHP (578) Y-Axis Tool Setup on Multi-Task Machines Parting and Setup in Y-Axis Direction Parting and Setup in X-Axis Direction - Optional Cutting edge is located: Cutting edge is located 27�5 mm from machine center line ( ) TGTBY 1� 30�82 mm from machine center TGTBY line ( ) in Y Axis 2� 3 mm from for TGAQ adapter and 6�4 mm for DGAQ adapter *27.5 REF (see sketches below) *30.82 REF X Feed (in X axis) Feed (in Y axis) *3 REF Y Machine Probe n Y Y X n Option 1 Option 2 For TGAQ For DGAQ Correct Correct Adapters Adapters Position X Position 3 REF 6.4 REF Setup cutting edge level on center line Setup cutting edge level on center line * For Y-Axis cut off, compensate 30�82 mm in Y-Axis direction * For X-Axis cut off, compensate 27�5 mm in Y-Axis direction� and compensate 3 mm for TGAQ adapters or Location pin should be removed� 6�4 mm for DGAQ adapters in X-Axis direction� Set the cutting edge on the center line: 1 8 Option 1 - Gauge the cutting edge - this is preferable due to better accuracy Option 2 - Gauge the blade and compensate 3mm / 6�4mm 1. Block: TGTBY 3 2. Locating pin: Side thrust Pin 3 mm 3. Clamping screw : SR M4x10 ISO 14580 2 Remove Pin for 4. Clamping & sealing screw: SR M4x9-Seal-JHP X-Axis Machinning 5. Seal washer: CSW 1/8’’ 6 6. O-ring: O-ring 10x2 NBR 4 7. Lower sealing plug: Plug G1/8-6�5 TL360 5 3 8. Upper sealing screw: SR M3x4-DIN913 7 Spare Parts Designation TGTBY-JHP SR M4X10-8.8-T20 SR M4X9-SEAL-JHP OR 16X2 NBR JHP COPPER SEAL 1/8" BLD T20/S7 SW6-SD PLG G1/8 TL360 HW 5.0 SIDE THRUST PIN 3mm 583