Каталог Sumitomo фрезы со сменными пластинами - страница 36

SEC-Sumi Dual Mill DFC Type ■ Difference in Applications between the DFC Series and WEX Series The DFC series is suited for high feed, high efficiency milling taking advantage of its cutting edge strength. The WEX Series is suitable for a range of applications in shoulder milling and deep shoulder milling. 15.0 WEX Series ・Wide range of applications ・Low cutting resistance ・Large depth of cut WEX Depth of Cut ap (mm) 10.0 DFC Series ・High strength, high efficiency milling 6.0 ・Cost effective with double- Work material sided inserts Series Steel Stainless Steel Cast Iron Exotic Alloy DFC WEX ◎ ◎ ◎ ◎ 2.0 DFC ◎ ○ ◎ ○ 0 0.1 0.2 0.3 0.4 Feed Rate Per Tooth fz (mm/t) ■ Series H Type Description Cat No. ø25 ø32 ø40 ø50 Diameter (mm) ø63 ø80 ø100 ø125 ø160 ø200 Cutters Milling Standard Pitch DFC 09000R/RS Q Q Q D D A A A A Face Milling Fine Pitch DFCM 09000R/RS Q Q Q D D A A A A Shoulder Milling High Feed Extra-Fine Pitch DFCF 09000R/RS Q Q Q D D A A A A Shell Type Radius Multi- Standard Pitch DFC 09000E D D D D/S D/S D/S Q Q Q Q Purpose R/ Profiling Fine Pitch DFCM 09000E Q D D D/S D/S D/S Q Q Q Q Groove/ Shank Type T-Slot D : Only metric in stock, A : Both metric and inch in stock, S mark: Shank diameter 42mm type (made-to-order), Blank : Made-to-order for both metric and inch, Q mark : We cannot produce Chamfering Aluminum/ Light Alloys High-Speed ■ Note for Inserts Set-up Cast Iron ○ There should be no gaps × No gap Gap Place the insert flatly on the seat of the cutter and tighten the screw with the recommended torque. H36