Общий каталог Tungaloy 2020 - 2021 - страница 990

Предыдущая страница Следующая страница

Навигация

Face mill arbors with center through-coolant hole

3 holes equally spaced Cutter diameter DC (mm) Nominal diameter DCONWS (mm)

Arbor type

50/6380100125160
2225.431.7538.150.8

FMH22 FMH25.4 FMH31.75 FMH38.1 FMH50.8

Notes on arbors: when using TAW13 or TPW13 type, use through center air.

Nominal diameter

162225.431.7538.150.8
DCONWS (mm)
Applicable arborSMAFMCFMAFMA
typesFMAFMA
SM1SM1FMCSMB
Through hole diameter
4 ~ 65 ~ 86 ~ 910 ~ 1310 ~ 1510 ~ 15

ød1 (mm) When using the TAW13 or TPW13 type with through center air (coolant or mist), the correct arbor must be used with through center air supplying.

■ Cautionary notes in use

ApproachIn slotting or pocketing, when chips are likely to remain in the cuttingThe inserts should be clamped by using the wrench supplied with the
anglezone, internal air supplying or air blow is recommended to prevent chipTAC Mill.
10°-20000°recutting.After a long period of use, the clamping screws and wrench may be-

Use of inserts other than those specifi ed, can result in poor cutting and come deformed or damaged. These elements must be replaced as soon cause damage to the cutter body. Therefore, specifi ed inserts from the as possible. 45° Tungaloy catalogue must be used. Before changing or indexing the inserts, remove chips or other foreign

matter from the insert, insert pocket and cutter body by using an air blast 70° or cloth.

85°

88°

90°

Others