Общий каталог Tungaloy 2020 - 2021 - страница 1043

Предыдущая страница Следующая страница

Навигация

R C M T- M J R C M T- N M J B

INSDS INSD S
C
R C M T- N A J
INSDS D
E
PSteel
MStainless
KCast iron
NNon-ferrous
SSuperalloys: First choice F
Hard materials: Second choice
H
Uncoated Coated
Designation APMXINSDS
RCMT1204EN-MJ6zzz124.8G
RCMT1204EN-NMJ6zzz124.8
RCMT1204FN-NAJ6z124.8
RCMT1606EN-MJ8zzz166.5
RCMT1606EN-NMJ8zzz166.5
RCMT1606FN-NAJ8z166.5H

z: Line up STANDARD CUTTING CONDITIONS

ISOWorkpiece materialHardness HBGradeCutting speed Vc(m/min)Feed eper tooth:fz ( ach chipbreakmm/t) er
MJNMJNAJ
Low carbon steels S15C, SS400, etc. C15E4, E275A, etc.~ 200AH725100 - 2200.2 - 0.70.17 - 0.3-
High carbon steels S45C, S55C, etc. C45, C55, etc.200 ~ 300AH725100 - 2000.2 - 0.70.17 - 0.25-
Alloyed steels SCM440, SCr415, etc. 42CrMo4, 20Cr4, etc.150 ~ 300AH725100 - 2000.2 - 0.70.17 - 0.25-
Tool steels SK, SKH, etc. X40CrMoV5-1, etc.~ 300AH725100 - 1800.2 - 0.70.17 - 0.25-
Stainless steels SUS304, SUS316, etc. X5CrNi18-9, X5CrNiMo17-12-3, etc.-AH14090 - 1800.2 - 0.60.15 - 0.25-
Grey cast irons FC250, FC300, etc. 250, 300, etc.150 ~ 250AH120140 - 2500.2 - 0.70.17 - 0.3-
Ductile cast irons FCD400, etc. 400-15S, etc.150 ~ 250AH120140 - 2500.2 - 0.70.17 - 0.3-
Aluminium alloys Si < 13%-KS15F500 - 1200--0.1 - 0.3
Aluminium alloys Si ≥ 13%-KS15F100 - 300--0.1 - 0.3
Heat-resisting alloy Inconel 718, Ti-6Al-4V, etc.-AH72520 - 500.2 - 0.60.15 - 0.25-
  • To remove excessive chip accumulation use an air blast.
  • Cutting conditions are limited by machine power and material
  • When chips stick to the cutting edges (aluminium machining), rigidity. When the cutting width or depth is large, set Vc and fz

use a water soluble cutting fl uid. below the recommended values and check the machine vibration and spindle load.