Общий каталог Tungaloy 2020 - 2021 - страница 1185

Предыдущая страница Следующая страница

Навигация

ISOWorkpiece materialGradesCutting speed Vc (m/min)Feed per toothfz (mm/t)
Low carbon steelAH725100 - 2000.1 - 0.3
High carbon steelAH72570 - 1500.1 - 0.3
High carbon steelsAH72570 - 1700.1 - 0.3
Cast steelAH72570 - 1700.1 - 0.3
Stainless steelAH72590 - 1400.1 - 0.3
Cast ironAH72560 - 1300.05 - 0.3
Aluminium alloysAH72580 - 4000.1 - 0.4
Heat-resistant alloysAH72510 - 300.02 - 0.1
Titanium alloyAH72520 - 900.02 - 0.1
  • Climb milling is recommended. Insert installation

1. Use airgun or rag to thoroughly clean all the insert pockets free from dust

or chips.

2. Lightly tighten Screw "A" first, then Screw "B" until the insert becomes

stationary.

3. Lightly tighten the screws for other insert(s) in the same matter as men-

tioned in #2 above. 4. Firmly tighten Screw "A", then Screw "B". Use the recommended torque strengths when tightening the screws.

5. Firmly tighten the screws for other insert(s) in the same manner as men-

tioned in #4 above.

6. Inspect to make sure there is no gap between the insert and the insert (B) (A)

seat. Measure the radial runout before use.

E

F

G

H

I

J

K

L

M