Общий каталог Tungaloy 2020 - 2021 - страница 583

Предыдущая страница Следующая страница

Навигация

Profiling B

GR Full radius type

Low cutting force and good chip 2.0 GR50 control for profi ling GR40 CW = 3 - 5 mm GR30 1.0 C 0.05 0.10 0.15 0.20 0.25 0.30 Feed: f (mm/rev)

F063 page D

For aluminium and non-ferrous metal

GE-AL Reduce cutting force and welding

0.30

due to sharp chipbreaker 0.25 E

CW = 2 - 4 mm 0.20 0.15 0.10 0.05

External

2 3 4 F

Groove width : CW (mm) F065 page STANDARD CUTTING CONDITIONS

ISOWorkpiece materialGradesCutting speed Vc (m/min)
T922580 - 300
Low carbon steel, Alloy steelT912580 - 200
( ~ HB150)NS9530100 - 200
GH73050 - 180
T922580 - 220
Medium carbon steel, Alloy steelT912580 - 180
(HB150 ~ 250)NS953080 - 180
GH73050 - 150
T922580 - 220
High carbon steel, Alloy steelT912580 - 150
(HB250 ~ )NS953080 - 150
GH73050 - 120
T922580 - 180
Stainless steelT912580 - 150
GH73050 - 120
T922580 - 250
Grey iron, Ductile cast ironT912580 - 200
GH73050 - 180
Aluminium alloy, Non-ferrous metalKS05F200 - 300
For External
Feed:f(mm/rev)
OperationGroove width: CW(mm)
2345
Grooving (GE)0.06 - 0.20.06 - 0.250.07 - 0.270.07 - 0.3
Parting off (GER/L)0.04 - 0.10.04 - 0.140.04 - 0.140.04 - 0.14
Traversing (GT)-ap = 0.5 - 1.5 f =0.06-0.2 Depth of cutap = 0.5 - 2 f =0.06-0.25 Depth of cutap = 0.5 - 2.5 f =0.06-0.27 Depth of cut
Profi ling (GR)-ap = 0.5 - 1.4 f =0.05-0.25 Depth of cutap = 0.5 - 1.5 f =0.05-0.26 Depth of cutap = 0.5 - 1.6 f =0.05-0.3 Depth of cut
Grooving for Aluminium alloys (GE-AL)0.03 - 0.10.03 - 0.10.03 - 0.1-
Toolhold Reference pages:ers→ F056 - F058For diameter compensation values in traversing, see pag