Общий каталог Tungaloy 2020 - 2021 - страница 681

Предыдущая страница Следующая страница

Навигация

For aluminium and non-ferrous metal

GE-AL Reduce cutting force and welding

due to sharp chipbreaker

CW = 2 - 4 mm

F163 page

STANDARD CUTTING CONDITIONS

0.25 B 0.20 0.15 0.10 0.05 C

2 3 4

Groove width: CW (mm) D

ISOWorkpiece materialGradeCutting speed Vc (m/min)
T922580 - 300
Low carbon steelT922580 - 200
( ~ HB150)NS9530100 - 200
GH73050 - 180
T922580 - 220
Medium carbon steel, Alloy steel (HB150 ~ 250)NS953080 - 180
GH73050 - 150
T922580 - 220
High carbon steel, Alloy steel (HB250 ~ )NS953080 - 150
GH73050 - 120
T922580 - 180
Stainless steelsGH73050 - 120
T922580 - 250
Grey iron, Ductile cast ironGH73050 - 180
Aluminium alloy, Non-ferrous metalKS05F200 - 300

Aluminium alloy, Non-ferrous metal KS05F 200 - 300 H

1st choice for face grooving

Feed:f(mm/rev)
OperationGroove width
345
Face grooving （GE）0.06 - 0.220.06 - 0.240.07 - 0.26
Face grooving （GF）0.04 - 0.250.05 ~ 0.260.05 - 0.30
Traversing （GT）ap = 0.5 - 1.5 f =0.06-0.2 Depth of cutap = 0.5 - 2 f =0.06-0.25 Depth of cutap = 0.5 - 2.5 f =0.06-0.27 Depth of cut
TraversingDepth of cutDepth of cutDepth of cut
（GR）ap = 0.5 - 1.4 f =0.05-0.25ap = 0.5 - 1.5 f =0.05-0.26ap = 0.5 - 1.6 f =0.05-0.3
Grooving for Aluminium alloys （GE-AL）0.03 - 0.10.03 - 0.1-

0.03 - 0.1 0.03 - 0.1 For diameter compensation values in traversing, F091 page When vibration occurs in turning, please use the lower limit value in the above table.

K

L

M