Общий каталог Tungaloy 2020 - 2021

ISO	Workpiece material	HB Brinell hardness	Priority	Grade	Cutting speed: Vc (m/min)	MJ Feedp	MS er tooth:fz	AJ (mm/t)
	Low carbon steel S15C	~ 200	First choice	AH725	100 - 250	0.10 - 0.18	-	-
	, etc. C15E4, etc.	~ 200	Wear resistance	T3130	100 - 250	0.10 - 0.18	-	-
	High carbon steel and alloy steel	200 ~ 300	First choice	AH725	100 - 200	0.08 - 0.14	-	-
	S55C, SCM440, etc. C55, 42CrMo4, etc.	200 ~ 300	Wear resistance	T3130	100 - 200	0.08 - 0.14	-	-
	Tool steel	150 ~ 300	First choice	AH725	100 - 200	0.08 - 0.14	-	-
	SKD11, etc. X153CrMoV12, etc.	150 ~ 300	Wear resistance	T3130	100 - 200	0.08 - 0.14	-	-
	Stainless steel SUS304, etc. X5CrNi18-9, etc.	-	-	AH130	100 - 150	-	0.08 - 0.15	-
	Grey cast irons	150 ~ 250	First choice	AH120	100 - 250	0.10 - 0.18	-	-
	FC250, etc. 250, etc.	150 ~ 250	Wear resistance	T1215 T1115	100 - 250	0.10 - 0.18	-	-
	Ductile cast irons FCD450 etc	150 ~ 250	First choice	AH120	80 - 200	0.10 - 0.18	-	-
	, . 450-10S, etc.	150 ~ 250	Wear resistance	T1215 T1115	80 - 200	0.10 - 0.18	-	-
	Aluminium alloys Si < 13%	-	-	DS1100	200 - 500	-	-	0.05 - 0.18
	Aluminium alloys Si ≥ 13%	-	-	DS1100	100 - 200	-	-	0.05 - 0.18
	Titanium alloys Ti-6AI-4V, etc.	-	-	AH130	20 - 60	-	0.08 - 0.14	-
	Superalloys Inconel718, etc.	-	-	AH725	20 - 40	0.06 - 0.12	-	-

Inconel718, etc.

To remove excessive chip accumulation use an air blast.
Cutting conditions are limited by machine power, workpiece rigidity, and
To avoid build up edge on the cutting edges (aluminium machining), use a spindle output. When the cutting width, depth, or overhang length is large, water soluble coolant. set Vc and fz to the lower recommended values and check the machine
When cutting an interrupted surface or a casted skin, the feed per tooth (fz) power and vibration. should be reduced to the lower recommended value shown in the above table.

Общий каталог Tungaloy 2020 - 2021 - страница 975