Общий каталог Tungaloy 2020 - 2021 - страница 1577

C P CTS P- CA

C l a m p - o n c a r t r i d g e , with 4 5 ° approach a n g l e , for 1 1 ° clearance triangular inserts B

20°

RELH L3 DMIN2

• In the above table, DMIN is the minimum bore diameter for axial mounting, and DMIN2 is for radial mounting.
• When using a right or left hand insert, use right-hand cartridges (R) with left-hand inserts (L); and left-hand cartridges (L) with right-hand inserts (R).
• **RE: Standard corner radius SPARE PARTS E

Axial adjusting Radial adjusting F

• Cartridges for K-style cutting edge: S0816A or S1016A; S-style cutting edge: S0816C or S1016B
• When not using chipbreaker piece, clamping screw in ( ) should be used. G

C E CTS E - CA

C l a m p - o n c a r t r i d g e , with 4 5 ° approach a n g l e , for 2 0 ° clearance triangular inserts

20°

LH L3 45˚ DMIN2 LF I Cutting edge style S

Right hand (R) shown.

• In the above table, DMIN is the minimum bore diameter for axial mounting, and DMIN2 is for radial mounting.
• When using a right or left hand insert, use right-hand cartridges (R) with left-hand inserts (L); and left-hand cartridges (L) with right-hand inserts (R). J
• **RE: Standard corner radius

SPARE PARTS

Designation Cartridge setting screw Wrench 1 Wrench 2 Wrench 3

CTSER10CA-11 CHHM6-15 P-2 P-2.5 P-5 K

Designation Clamping screw Axial adjusting Radial adjusting Chipbreaker piece Sizing plate ass’y

M Reference pages: CP CTSP-CA: Inserts → B142 -, CBN → B185 -, PCD → B196 CE CTSE-CA: Inserts → Special