Общий каталог Tungaloy 2020 - 2021 - страница 1151

Предыдущая страница Следующая страница

Навигация

WRENCH

K E Y V- . . . , K E Y V- S . . . , K E Y V-T. . . , K E Y V-T * * L , K E Y V- W 2 0

AppearanceDesignationConnection screw sizeTorque (N·m)Applicable head
KEYV-S05S057Square
KEYV-S06S0610Ball
KEYV-S08S0815Radius
KEYV-S10S1028Drilling
KEYV-S12S1228Chamfering
KEYV-W20S1540Counter boring
KEYV-177S0610Slottin VST te
KEYV-217S0815g yp
KEYVT40LS0815Slttin VST VTB t
-S1028og , ype
KEYVT20S057
-S0610
KEYV-T25S0610Sltti VTB t
KEYV-T30LS0815ong ype
S0815
KEYV-T50LS1028

Note: Wrenches are sold separately.

CAUTIONARY POINTS IN USE

  • The cutting heads specifi ed by Tungaloy must be used. Avoid using alternate heads that are not Tungaloy products as this will damage the shank and can cause severe accident or injury.
  • Before setting the head, clean the connection screw with an air blast or a wiping cloth to remove chips and other foreign matter that may remain.
  • Do not apply the lubricant to the connection screw.
  • Please use the correct “Wrench” with the correct cutting head. Tighten the head slowly until the face of the head contacts the shank. (Please refer to the picture shown on the right.) Do not re-tightening or over-tightening. Excessive tightening may cause the cutting head to break.
  • Do not apply excessive force or a hammer when tightening or exchanging the cutting heads.

OK

Gap

F

G

H

I

J

K

L

M