Каталог Sumitomo сверла и развертки - страница 120

SEC-Plunge Drill

PDL

Type (2D,3D)

Fig 1 Fig 2 DCS FMS DCS FMS

LU LU LUX LUX

LPR LS LPR LS

OAL OAL

• Holders Max. Depth : 2D
• Holders Max. Depth : 3D

(mm) (mm)

Effective Length Length Below Neck Overhang Length Total length Shank Boss Side Lock Flat Applicable Effective Length Length Below Neck Overhang Length Total length Shank Boss Side Lock Flat Applicable

DC Cat. No. Fig DC Cat. No. Fig

LU LUX LPR OAL LS DCSFMS DCON Insert LU LUX LPR OAL LS DCSFMS DCON Insert

Fig 3 Fig 4 Fig 5 Holder Identification

W1 RE W1 RE W1 RE PDL 250 D2 S25

(ø25.0) Flute Length L/D (ø25.0)

L Type: Low feed, chip G Type:General purpose H Type:Strong edge type Insert Identification

management WDXT 07 35 06 -G

• Inserts

Width Across Flats Thickness×10 Breaker Type

General Purpose P Steel M Stainless Steel K Cast Iron

(Insert is common with the WDX Type) (mm) Recommended Tightening Torque(N・m)

N m Reamer

• Notes About Mounting Inserts

Brazed Others

Central Insert NNNNNNNNNNNNNNNNNNew InsertNNNNNNNNNNNNNNew Inserteeeeeeew wチチチチチチチチIInnnsessseeeeeeerププ 使用済ププププププププププププププrtrtttttt使使使使使使使用使用使Used InsertUsUUUUUUUUsUUs dUsed Insert用ssedssed済済済済済済チ済チ済済ddIIIIチチチチnnsernnップッップeereeeeeeerププププププププrtrtrrttt

Peripheral Insert

PDL type: Inserts can be used on either the center or the outside, and 2 corners are used. Inserts used on the outside cannot be used in the center. Similarly, inserts used in the center cannot be used on the outside.