Общий каталог ZCC-CT 2019 - страница 717

Indexable milling Recommended cutting data Recommended feed rate A Indexable milling – group 6 (FMD03, FME04, FMP03, HMP01) Feed rate per cutting edge [mm] FMD03 FMD03 FME04 FMP03 FMP03 FMP03 Material group LNKT20 LNKT25 LNKT15 LNKT12 LNKT15 LNKT20 Turning Application F M R F M R F M R F M R F M R F M R Unalloyed steel 0,50 0,50 0,45 0,45 0,45 0,50 P Low-alloyed steel 0,47 0,47 0,42 0,42 0,42 0,47 High-alloyed steel and high-alloyed tool steel 0,44 0,44 0,40 0,40 0,40 0,44 M Stainless steel 0,45 0,45 0,40 0,40 0,40 0,45 B Grey cast iron K Cast iron with spheroidal graphite 0,55 0,50 0,55 0,50 0,50 0,45 0,50 0,45 0,50 0,45 0,55 0,50 Malleable cast iron 0,50 0,50 0,45 0,45 0,45 0,50 Aluminum wrought alloys N Aluminum cast alloys Copper and copper alloys (bronze/brass) Milling Heat-resistant alloys S Titanium alloys Hardened steel H Hard cast iron Hardened cast iron X Non-metallic materials C Note: The given cutting values are guide values, which were determined under ideal conditions. The values have to be adapted in individual cases. Indexable milling – group7 (XMR01, XMP01) Drilling Feed rate per cutting edge [mm] XMR01 face milling XMR01 plunge milling XMR01 circular milling Material group SDMT/WPGT SDMT/WPGT SDMT/WPGT Tool diameter [mm] 20-25 30-50 63-160 20-25 30-50 63-160 20-25 30-50 63-160 Unalloyed steel 1,00 1,20 2,00 0,20 0,25 0,30 0,80 0,96 1,40 D P Low-alloyed steel High-alloyed steel and high-alloyed tool steel 0,93 0,70 1,12 0,84 1,86 1,40 0,19 0,18 0,23 0,22 0,28 0,26 0,74 0,70 0,89 0,84 1,30 1,23 M Stainless steel 0,50 0,60 1,00 0,14 0,18 0,21 0,56 0,67 0,98 Grey cast iron 0,90 1,08 1,80 0,22 0,28 0,33 0,88 1,06 1,54 Information K Cast iron with spheroidal graphite 0,90 1,08 1,80 0,20 0,25 0,30 0,80 0,96 1,40 Technical Malleable cast iron 1,00 1,20 2,00 0,20 0,25 0,30 0,80 0,96 1,40 Aluminium wrought alloys N Aluminum cast alloys Copper and copper alloys (bronze/brass) Heat-resistant alloys S Titanium alloys Hardened steel E H Hard cast iron Hardened cast iron X Non-metallic materials Note: The given cutting values are guide values, which were determined under ideal conditions. The values have to be adapted in individual cases. Index B 254