Общий каталог Yamawa 2022 - 2023 - страница 446

JIS IHT

Hand Taps for General Purpose

Specification M10×1.5 UNC Chamfer: 5P Tap dril size 8.5mm(ref.)

<2D

Oxide

Recommended Tapping Speeds depending on Materials

Low carbon steels Medium carbon steels

低炭素鋼5 中炭素鋼5

(m/min) (m/min)

Blister Pack

Product Features How to use IHT

• IHT is for hand tapping and for re-threading, and is used for
• Start tapping after boring holes corresponding to the thread

both through hole and blind hole. size by using drills (note: For drill sizes, refer to drill sizes

• Use for threading of the iron (SPC or SS400) products used shown in the bored hole size table.) in our daily life. On hand tapping, operate tapping in an upright position
• Surface treated. Oxidization, the most suitable surface parallel to bored holes by using tap wrenches. treatment for iron products. ●During tapping, please use tapping oil.
• Suitable for internal thread cutting in small quantity, such as tapping of test pieces.
• The 5 thread chamfer is recommended for through holes and 2 thread chamfer is recommeded for blind holes.

When hand tapping, always use Machine tapping with drilling

Through hole = 5 thread type Blind hole = 2 thread type tap wrench machine

■Table for bored and drilled hole sizes unit：mm

note1) Recommended drill sizes shown in this table are for internal threads of 7H class（3rd class), and are selected from the standard drills available in the market. note2) Drill sizes shown in brackets in this table are for such case as the drilling has oversize cutting tendency or for internal threads of 6H class（2nd class).

【Related products】

Shank adjuster

●For deep hole tappings, please use shank adjusters.

• There is only a one touch motion required to detach and attach the I series taps (IHT/ISP/IPO) from or to the shank adjuster.

＊For details of shank adjuster, refer to ⑦-77

④-49 video site shown in right