Основной каталог Kyocera 2021 - 2022 - страница 697

Coolant dry machining is not recommended.

1st recommendation

Internal coolant

Internal and external coolant is recommended In case of external coolant

Drilling depth less than 1DC Stainless steel, high feed rate

How to attach inserts

1 Install insert onto the toolholder in the right direction 2 Tighten clamp screw to fix the insert

1

2

Lathe: 3DC or less Vertical M/C: 1.5DC or less

KK

Be careful of the insert direction

• 1 Remove dust on insert pocket using air blow for every replacement.
• 2 Make sure that the locating surfaces of the insert closely contacts the toolholder.

Core deviation

If drill is stationary If drill is rotating

MAX. 0.02mm

MAX. 0.02mm

This can be used with a boring sleeve and collet chuck, please be sure to set Make sure to use arbor that is not deformed. deviation amount 0.02mm or under between workpiece and drill. Center of arbor deviation must be within 0.02mm.