Основной каталог Kyocera 2021 - 2022 - страница 566

KGD: Recommended cutting conditions (feed rate / ap)

Workpiece material: S50C Grooving Grooving CW CW

f f In the graph below indicates the most recommended value of feed (f) In the graph below indicates the most recommended value of feed (f)

2.5 6 ~8 5 GG 4

keep ap less than or equal to the corner-R(RE). 0.05 0.1

f (mm/rev) Note 1. The above values are based on the condition that CDX of toolholder is 17 mm or less. 6 5

4 3 2

0.05 0.10 0.15 0.20 0.25

f (mm/rev)

6 5 4 3 2

0.05 0.10 0.15 0.20 0.25

f (mm/rev)

CM chipbreaker [Cutting amount (ap) in back copying]

Maximum ap in back copying