Основной каталог Kyocera 2021 - 2022 - страница 498

Предыдущая страница Следующая страница

Навигация

GMM/GMN/GMR

Non-ferrous metalsNN
Titanium alloyNS
Hard materials (~40 HRC)
H
Hard materials (40 HRC ~)O N
Dimension (mm)ToleranceCBN PCD
InsertDescription
CWCW
CWSRELEINSL
min.max.
GMN 2124.30.22.920- 0.05 + 0.05U U
E008U U
0.2U U
GMN 3134.32.920- 0.05 + 0.05
LE2°E0080.4U U
2°0.2U U

RE GMN 4 1 4 4.3 2.9 20 - 0.05 + 0.05 G45-G47

INSLE0080.4
U U
1-edge0.2U U

GMN 5 1 5 4.3 2.9 20 - 0.05 + 0.05

E0080.4U U
G0.2

GMN 6 1 6 4.3 2.9 20 - 0.05 + 0.05 U

E008 0.4 U U

Handed insert shows Right-hand Available cutting diameter of KGM (for automatic lathe) / KGM-T (There is a limit to available grooving depth depending on the workpiece diameter.)

20 (CDX, ø40) 18 (CDX, ø130)

ø130 (Cutting dia.) ø40

If the workpiece diameter is large, the available grooving depth becomes smaller due to interference with the toolholder. e.g.) KGMR2525M-3T20+GMN3

KGM (for automatic lathe) possible cutting diameter and available grooving depth

Toolholder description DCX (Cutting Dia.)

KGM& 0810K-1.5-125------- --- -- 10 14 16 32
1010 □-1.5 …------- 20 25 32 40 60
1212-1.5 … ----25 26 28 32 36 40 60 100
0810K-2-125------- --- -- 10 14 16 32
1010 □-2 …------- 20 25 32 40 60
1212-2… ----25 26 28 50
1616-2… 32 40 50 60 80 100 ∞ ∞
1212-2.5… ----25 26 28 32 36 40 60 100
1616□-2.5…32 40 50 60 80 100
1616-3… 32 40 50 60 80 100
Available CDX (mm)16 15 14 13 12.5 12 11 1098 71 2 3 4 6 5
KGM-T possible cutting diameter and available grooving depth (GMN, GM& when using 1-edge insert)
Toolholder descriptionDCX (Cutting Dia.)
KGM& 2012K-2T17
2020K-2T17-------260 130 80 66 -
2525M-2T17
1616H-3T20-----4054180 100 70
2012K-3T20
2020K-3T20
2525M-3T20-----4090∞ 240 130
2020K-4T20∞ ∞
2525M-4T20∞
2525M-4T25
--50140240
2525M-5T25
3232P-5T25--50280600
2525M-6T30100300∞∞∞
Available CDX (mm)30272523222019<13 14 15 16 17 18