Основной каталог Kyocera 2021 - 2022 - страница 331

Предыдущая страница Следующая страница

Навигация

Selection of system tip-bars

Gang-Type Gang-Type

Gang-Type (Horizontal) Gang-Type Front loading sleeve type Back loading sleeve type

Sleeve holder Face side Back side Main spindle

Unable to insert a holder from face side because of too narrow space.

Square shank (Straight) Square shank (L-shape) Square shank Square shank

Round shank (Standard)Round shank (Standard)Round shank (Standard)FF
Round shank (Straight)Round shank (Straight)Round shank (Straight)

Q: There are standard types (head dia. is larger than shank) and straight types for round shanks. What is each one used for? A: The straight type is used when it cannot be inserted from the face side of the sleeve holder and can be inserted only from the back side due to space limitation (Refer to fig. above). On the other hand, the standard type should be installed when it can be inserted from the face side, and the head end is used for positioning as stopper.

Attachment toolholder for VNBX-S system tip-bars

1. There are three different types of attachment toolholder for the VNBX-S system tip-bars. 1. SVNS-XN type (without side stopper) 2. S···SVN-XN type (without side stopper) 3. S···SVN-SXN type (without side stopper) 2. These toolholders assure high index accuracy by easy restraint. 3. Setscrews (SP3x4) are attached. Toolholders without side stopper can be used as a binding effect toolholder when removing the clamp screws and inserting screws (HS3x4: sold separately) with a wrench (LW-1.5: sold separately).

Sleeves for boring bars: How to install

1. For turret type tool post Back cover Back cover screw

Coolant sleeve (SHC{{{{- {{)

Boring bar with coolant hole Rc1/8

Clamp screw (for boring bars) Joint (R1/ ) 8 Pipe

2. For gang type toolpost

Boring bar with coolant hole

Joint Pipe (R 1/8) Coolant joint (SJS-○)

Washer（WB-○） * Washer attached to coolant joint