Общий каталог Mitsubishi 2020 - 2021 - страница 857

Предыдущая страница Следующая страница

Навигация

Ball nose, Short cut length, 2 flute, Short shank MP2SSB

Ball nose, Short cut length, 2 flute MP2SB Ball nose, Medium cut length, 2 flute MP2MB

CARBIDE

RECOMMENDED CUTTING CONDITIONS

Work MaterialHardened Steel (45─55HRC)Copper, Copper Alloy
RE%15°%>15°Depth of cutDepth of cut%15°%>15°Depth of cutDepth of cut
(mm)Revolution (min-1)Table feed (mm/min)Revolution (min-1)Table feed (mm/min)ap (mm)ae (mm)Revolution (min-1)Table feed (mm/min)Revolution (min-1)Table feed (mm/min)ap (mm)ae (mm)
R0.140000300400002500.0030.0240000300400002500.0030.02
R0.1540000500400003500.0070.0340000500400003500.0070.03
R0.2400001300400009500.0150.04400001300400009500.0150.04
R0.254000019004000011000.020.054000019004000011000.020.05
R0.34000025004000013000.0250.064000025004000013000.0250.06
R0.44000040004000019000.040.084000040004000019000.040.08
R0.54000056004000030000.050.14000056004000030000.050.1
R0.754000065003200032000.080.154000065003200032000.080.15
R14000065003100035000.110.24000065003100035000.110.2
R1.253600065002600035000.120.253600065002600035000.120.25
R1.53200060002200034000.130.33200060002200034000.130.3
R22500060001600027000.150.42500060001600027000.150.6
R2.52000054001300023000.20.52000054001300023000.20.8
R31700047001000020000.250.61700047001000020000.250.9
R4130003600800015000.30.8130003600800015000.31.6
R5100002900640012000.51.0100002900640012000.52.0
R672002000480010000.51.285002300530011000.52.4
Depth of
Cut

I < Note 1) % is the inclination angle of the machined surface. Note 2) If the depth of cut is shallow, the revolution and feed rate can be increased. Note 3) If the rigidity of the machine or the work materials installation is very low, or chattering and noise are generated, reduce the revolution and feed rate proportionately.

End Mill

RE

ap ae