Profile MillingSlot MillingShoulderMillingFace MillingHigh FeedMilling Cutting depth: ap (mm)Cutting depth: ap (mm) APMX APMX RMPX A A P P L I C AT I O N RANGE LQMU11-PXER-MJ Helical interpolation Hole enlarging Plunging and Shoulder Slotting Ramping traversing milling Feed øD1, 2 øD3, 4 ae Max. depth Max.rampingof cutangleMax. Min.plungingmachiningMax. machining Max. cuttingwidth inenlarging Designation DC APMX RMPX A øD1 øD2 * øD3 øD4* RE ae EPQ11R025… 25 9 1.8º 0.6 35 46.8 49 48.5 0.8 24.1 EPQ11R032… 32 9 1.3º 0.6 48 60.8 63 62.5 0.8 31.1 TPQ11R040… 40 9 0.9º 0.6 64 76.8 79 78.5 0.8 39.1 TPQ11R050… 50 9 0.7º 0.6 84 96.8 99 98.5 0.8 49.1 TPQ11R063… 63 9 0.5º 0.6 110 122.8 125 124.5 0.8 62.1 Approachangle TPQ11R080… 80 9 0.4º 0.6 144 156.8 159 158.5 0.8 79.1 10°-20° TPQ11R100… 100 9 0.3º 0.6 184 196.8 199 198.5 0.8 99.1 *For a flat bottom 45° 70° NOTE WHEN USING L Q M U 11 INSERTS Maximum feed rate per tooth varies depending on the cutting depth and width. 85° Use proper feed rate as described below. Use caution. Tool may damage if the parameters are not properly set. 88° Applicable feed rate (for ae < 10% of tool diameter) 90° 10 9 8 Cutter : TPQ11R050M22.0-06 (DC = 50 mm, z = 6) Others 7 Insert : LQMU110708PXER-MJ 6 Grade : AH3135 5 Workpiece material : S55C (200HB) 4 Cutting Speed : Vc = 200 m/min 32 Cutting width : ae = 5 mm 1 Coolant : Dry 0 Machine : Vertical M/C, 22 kW 0.1 0.2 0.32 0.4 Feed per tooth: fz (mm) Applicable feed rate (for ae > 10% of tool diameter) 10 98 Cutter : TPQ11R050M22.0-06 (DC = 50 mm, z = 6) 7 Insert : LQMU110708PXER-MJ 6 Grade : AH3125 5 Workpiece material : S55C (200HB) 4 Cutting Speed : Vc = 200 m/min 3 Cutting width : ae = 42.5 mm 2 Coolant : Dry 1 0 Machine : Vertical M/C, 22 kW 0.1 0.2 0.32 0.4 Feed per tooth: fz (mm) H170 www.tungaloy.com