Общий каталог Tungaloy 2020 - 2021 - страница 645

Предыдущая страница Следующая страница

Навигация

WF DCONMS B GradeInsertExt. ToolholderInt. ToolholderThreadingGroovingMiniature toolMilling cutterEndmillDrilling toolTooling SystemUser's GuideIndex STANDARD CUT TING CONDITIONS A ISO Workpiece material Grade Cutting speed FeedVc (m/min)f (mm/rev) NS9530Medium carbon steelsUX30 80 - 20060 - 150 0.05 - 0.080.05 - 0.08 B Cast irons, Light alloys TH10 60 - 150 0.05 - 0.08 Note: • Please use the above values as a guide for selecting cutting conditions.• The values will vary for machining the diameter close to the minimum value or with long overhang of the toolholder.In that case, please reduce the above values to approximately half• To help chip evacuation, please use water-soluble coolant. The coolant should sufficiently reach the cutting point.C When coolant cannot be used, please reduce the above values (both speed and feed) to less than half. CGXR/L D Internal grooving LFLHDMIN2° H E CWN-CWX 2° Right hand (R) shown. F Designation Material CWN CWX DMIN CDX DCONMS H B LF LH WF Insert Torque* CGXR/L0016 Steel 1 3 20 3 16 15 15.5 150 24 11.3 GIR/L52... 2.2 CGXR/L0020 Steel 1 3 24 3 20 18 19 180 30 13.3 GIR/L52... 2.2CGXR/L0025Steel15325.32523242003818GIR/L63...5CGXR/L0032Steel15405.33230312504823GIR/L63...5G CGXR/L0040 Steel 1 5 48 5.3 40 37 38.5 300 60 27 GIR/L63... 5 CGXR/L16SC Carbide 1 3 20 3 16 15 - 200 24 11.3 GIR/L52... 2.2 Note: Use right-hand holder (CGXR) with right-hand insart (GIR); and left-hand holder (L) with left-hand insart (GIL).*Torque: Recommended clamping torque (N∙m) H SPARE PARTS Designation Clamp set Wrench1 Wrench2 CGXR /L00 16/20 CSW-0 - P-2.5T CGXR /L00 25/32/40 CSW-2 P-4 -CGXR/L16SCCSW-0-P-2.5T I J K L M Reference pages: Inserts, Standard cutting conditions → F130 Tungaloy F129