Общий каталог Mitsubishi 2020 - 2021 - страница 350

OPERATIONAL GUIDANCE

Notes when end face profiling Not possible

Pay special attention to the Machining of V-pulleys

following when face profiling. Depth from end face Up to .394" Machining of an outer diameter (Step z) Inclination angle 60° or less To prevent burr formation, the depth of cut should be less than half the corner radius.

2 Machining of an inclination (Step x) C

• To reduce the contact length of chips, the depth of cut should be less than half the corner radius.

1 To prevent interference between the tool and the work material, the cutting diameter should be 1.575" or larger, inclination angle 60° or less and depth from the Cutting diameter ø1.575" or larger end face up to .394".

When changing inserts

• When indexing the inserts, it is recommended to preset the cutting edge position to maintain machining When machining V-pulleys, accuracy. use a VNMG insert

TECHNICAL DATA P001 C039