Общий каталог Mitsubishi 2020 - 2021 - страница 1108

Предыдущая страница Следующая страница

Навигация

CARBIDE

RECOMMENDED CUTTING CONDITIONS

yy Shoulder Milling (L/D=3)

Other than the L/D = 3, use following recommended cutting conditions by multiplying the J003 page correction factor by overhang length. (inch)

Wo Matrk erialAustenitic Ferritic andStainless St Martensitieel, c Stainless SteelPrecipitati Titanium Aon Hardenin lloyg StainlessSteel,Heat Resistant Alloy
DC (mm)No. of FlutesRevolution n (min-1)Feed Rate vf (IPM)Depth of Cut apWidth of Cut aeRevolution n (min-1)Feed Rate vf (IPM)Depth of Cut apWidth of Cut aeRevolution n (min-1)Feed Rate vf (IPM)Depth of Cut apWidth of Cut ae
8812000378.0.012.0478000252.0.012.047240059.1.012.031
10109500374.0.012.0596400252.0.012.059190059.1.012.039
15126400362.2.012.0874200236.2.012.087130063.0.012.059
15156400378.0.012.0874200248.0.012.087130063.0.012.059
19125000283.5.012.1103400192.9.012.110100047.2.012.075
19155000295.3.012.1103400200.8.012.110100047.2.012.075
Depthof Cutaeap

Note 1) Vibration may occur if the rigidity of machine or work material is low. In this case, please reduce the revolution and the feed rate proportionately, or set a lower depth of cut. Note 2) The use of water-soluble coolant is effective.

J