Общий каталог Mitsubishi 2020 - 2021 - страница 1038
Навигация
Каталог Mitsubishi Materials запасные части
Каталог Mitsubishi Materials резьбонарезной инструмент
Каталог Mitsubishi Materials СНП с CBN и PCD для токарной обработки
Каталог Mitsubishi Materials сверлильные инструменты
Каталог Mitsubishi Materials расточной инструмент
Каталог Mitsubishi Materials пластины для точения 
CBN
RECOMMENDED CUTTING CONDITIONS
| Work Material | Hardene AISI H13 | d steel(45 etc. | ─55HRC | ) | Hardene AISI D2 e | d steel(55 tc. | ─62HRC | ) | Hardene AISI W1, | d steel(62 AISI M2 et | ─70HRC c. | ) | |||
| DC | Revolution | Table | feed | Depth of cut | Width of cut | Revolution | Table | feed | Depth of cut | Width of cut | Revolution | Table | feed | Depth of cut | Width of cut |
| (mm) | (min-1) | (mm/min) | (IPM) | ap (mm) | ae (mm) | (min-1) | (mm/min) | (IPM) | ap (mm) | ae (mm) | (min-1) | (mm/min) | (IPM) | ap (mm) | ae (mm) |
| 0.5 | 50000 | 750 | 29.5 | 0.01 | 0.2 | 50000 | 600 | 23.6 | 0.01 | 0.1 | 40000 | 400 | 15.7 | 0.005 | 0.06 |
| 1 | 38000 | 1100 | 43.3 | 0.02 | 0.3 | 38000 | 760 | 29.9 | 0.01 | 0.2 | 25000 | 400 | 15.7 | 0.01 | 0.1 |
| 1.5 | 25000 | 900 | 35.4 | 0.03 | 0.5 | 25000 | 700 | 27.6 | 0.02 | 0.4 | 17000 | 340 | 13.4 | 0.02 | 0.2 |
| 2 | 20000 | 800 | 31.5 | 0.04 | 0.7 | 20000 | 600 | 23.6 | 0.03 | 0.6 | 12000 | 300 | 11.8 | 0.02 | 0.3 |
| Depth of cut | ae |
Note 1) If the depth of cut is smaller than this table, feed rate can be increased. Note 2) Oil mist coolant is recommended. Note 3) Cutting conditions may differ considerably due to the overhang, depth of cut, and machine tool conditions. Please use the above table as a start reference point.