Основной каталог Winstar 2021 - страница 215

Предыдущая страница Следующая страница

Навигация

Table 006

H680 Seires EHSSF4, EHSLF4, EHCSF4, EHCLF4

Side Milling

Work MaterialConditionCuttingCuttingDiameter (d)
RangeDepthConditionØ1Ø2Ø3Ø4Ø6Ø8Ø10Ø12
ap=1.5DRPM35000175001200087005830438035002900
Pre-Harden Steels HRC 3~4High Speedae=0.05DFeed(mm/min)630830100010001100110011001100
( 55) NAK80,CENA1ap=1.5DRPM2550012700850063504200320025002150
Generalae=0.07DFeed(mm/min)460510550600750800750700
ap=1.5DRPM32000160001100080005300400032002750
Hardened SteelsHigh Speedae=0.02DFeed(mm/min)6007508008509001000900850
(HRC 45~60) SKD61,SKD11,SKH51ap=1.5DRPM2200011200740056003750280022002000
Generalae=0.05DFeed(mm/min)360440460500560600580550

Slotting Milling

ConditionCuttingCuttingDiameter (d)
Work MaterialRangeDepthConditionØ3Ø4Ø5Ø6Ø8Ø10Ø12
Pre-Harden Steelsap=0.5DRPM7690580046403770290023201890
(HRC 35~45) NAK80,CENA1Generalae=1DFeed(mm/min)460580670610580550520
Hardened Steelsap=0.2DRPM3990300024301950150012001020
(HRC 45~60) SKD61,SKD11,SKH51Generalae=1DFeed(mm/min)200240300330300270240

1.Use as highly rigid and accurate machine as possible. 2.If the rpm available is lower than the recommend condition, please reduce the feed rate to the same ratio. 3.Use long shank type please reduce the rpm and feed rate. 4.The Feed and RPM may be changed depending on the M/C conditions ,lubricating and cooling system.