Общий каталог Widia 2017 - страница 873

Предыдущая страница Следующая страница

Навигация

Slotting Mills M16 P

Slot Width Range: M 11–21,9mm K

Indexes per insert: 2 Diameter: 25–50mm

Pages: L4–L7

„ Insert Offering

Inserts with positive chipbreaker providing low cutting forces.

T-Slotting

Steel Cast Iron

  • If machining a vertical slot, minimise depth; reference Figure 1.
  • Fewer problems with chip evacuation and reduced
If the depth is greater than Figure 1, chip evacuation problemscutting forces enable deeper vertical slots as shown
could occur.in Figures 2 and 3.
  • Vibrations could occur when the T-slot cutter diameter increases; use Figure 1 as the starting point. If vibrations are a concern, adopt the Figure 2 solution.

Figure 1 Figure 2 Figure 3

1–3mm C/2

C

NOTE: Air blast is recommended to disperse the chips.