Общий каталог Widia 2017 - страница 476

CM Cut-Off Medium Double-ended, V-bottom, and top, mechanically clamped.

• Neutral, right-, and left-hand lead angles up to 12˚.
• Designed to increase speed and feed.
• Chip geometry designed for excellent chip control and minimised cutting pressure on various materials.

CM-W Cut-Off Wiper fl ats where surface fi nish is critical.

• Double-ended, V-bottom, and top, mechanically

Medium with Wiper

clamped.

• Neutral, right-, and left-hand lead angles up to 12˚.
• Designed to increase speed and feed.
• Chip geometry designed for excellent chip control and minimised cutting pressure on various materials.
• Ideal for 300 Series stainless steel, tool steel, titanium, INCONEL ®, and other nickel-based alloys at moderate speeds and feeds.

PT Plunge, Groove, High positive rake geometry for low cutting force, especially in soft materials.

and Turn Inserts

• Deep grooving tool for plunge and turn O.D. and face grooving operations.
• Delivers chip control over full range of DOC when turning.
• Cuts in both axial and radial directions.

PC Grooving and Superior chip control.

• Full nose radius geometry for plunge

Profi ling Inserts

and contour operations.

• Effective cutting edge geometry exceeds 180° for increased versatility.

0,30 0,28 0,25 0,23 0,20 0,18 0,15 0,13 0,10 0,08 0,05

width of cut 1,5 and 2,0 2,5 3,0 4,0

[mm] 1 Recommended Starting Feed 6,3

5,5 size 8 size 7 4,0 size 6 size 5 2,5 size 4

1,6 size 3

1,0 size 2

R0,2 R1,06 0,5

turn/profi le feed 0,1 0,16 0,25 0,4

mm/rev

plunge groove feed 0,05 0,1 0,16 0,30

mm/rev

PH Plunge, Groove, Excellent performance in greater than 35 HRC.

• Deep grooving tool for plunge and turn O.D.

and Turn Inserts

and face grooving operations.

• Delivers chip control over full range of DOC when turning.
• Delivers superior chip control in interrupted cuts.

6,3

5,5

4,0 size 8 size 6 2,5 size 5

size 4 1,6 size 3 1,0 size 2

0,5

turn/profi le feed 0,1 0,16 0,25 0,4

mm/rev

plunge groove feed 0,05 0,1 0,16 0,30

mm/rev