Каталог Tungaloy инструмент для автоматов швейцарского типа - страница 279

Предыдущая страница Следующая страница

Навигация

AppearanceDesignationStockConnection screw sizeTM Head descriptionTorque (N∙m)
HandleTORQUEWRENCH5-50NM9x12●---
hes for eadsTM-WRENCH-6-05●S057
wrenc drical hTM-WRENCH-8-06●S06VEH, VED VEE, VEE-I VDP, VCA10
Open cylinTM-WRENCH-10-08●S0815
ches eadsTM-WRENCH-4E-05●S057
n wren flute hTM-WRENCH-5E-06●S06VCP, VGC VCW10
Ope for 2TM-WRENCH-7E-08●S0815
90° adaptor for Torx bitsINSERT-TOOL-9X12MM●---
socketsBIT-SOCKET-T25-DRIVE●S05, S06VFM10
Torx bitsBIT-SOCKET-T40-DRIVE●S08VFM15, 28

5

WRENCH

KEYV-S... , KEYV-T... , KEYV-T**L

AppearanceDesignationConnection screw sizeTorque (N·m)Applicable head
KEYV-S05S057Square
KEYV-S06S0610Drilling Chamfering
KEYV-S08S0815Counter boring
KEYV-T40LS0815
VFM type
KEYV-T25S05, S067, 10

VFM type 7 Note: Wrenches are sold separately.

CAUTIONARY POINTS IN USE

  • The cutting heads specifi ed by Tungaloy must be used. Avoid using alternate heads 8 that are not Tungaloy products as this will damage the shank and can cause severe OK accident or injury.
  • Before setting the head, clean the connection screw with an air blast or a wiping cloth to remove chips and other foreign matter that may remain.
  • Do not apply the lubricant to the connection screw.

Gap

  • Please use the correct “Wrench” with the correct cutting head. Tighten the head slowly until the face of the head contacts the shank. (Please refer to the picture shown on the right.) Do not re-tightening or over-tightening. Excessive tightening may cause the cutting head to break. 9
  • Do not apply excessive force or a hammer when tightening or exchanging the cutting heads.