Общий каталог SGS 2021 - страница 53

METRIC
Z-Carb
ADVANCED PRODUCTIVITY 38°
35°
4
≠ ≠


LF
APMX
DC DCON
Z1M
METRIC SERIES
TOLERANCES (mm) mm EDP NO. • Variable rake geometry
3–6 DIAMETER CUTTING LENGTH OVERALL SHANK Ti-NAMITE-X JetStream alters and controls the
DC = +0,000/–0,030 DIAMETER OF CUT LENGTH DIAMETER (TX) cutting dynamic taking
DC APMX LF DCON chatter suppression to
DCON = h 6 an unprecedented level
3,0 8,0 57,0 6,0 46357 –
>6–10 DIAMETER 4,0 11,0 57,0 6,0 46358 –
• Unequal helix design
reduces damaging
DC = +0,000/–0,040 5,0 13,0 57,0 6,0 46359 – harmonics by changing
DCON = h 6 the angle at which each
6,0 13,0 57,0 6,0 46360 – cutting edge enters and
>10–25 DIAMETER 8,0 19,0 63,0 8,0 46362 – exits the material
DC = +0,000/–0,050 • Unequal flute spacing
10,0 22,0 72,0 10,0 46364 – helps to disrupt the
DCON = h 6
12,0 26,0 83,0 12,0 46366 – rhythmic pattern
created by the cutting
14,0 26,0 83,0 14,0 46368 46506 edge helping to
STEELS
16,0 32,0 92,0 16,0 46370 46507 suppress damaging
harmonics
STAINLESS STEELS
18,0 32,0 92,0 18,0 46372 46508 • Optimal material
CAST IRON 20,0 38,0 104,0 20,0 46374 46509 removal rates through
increased feed and
HIGH TEMP ALLOYS
25,0 38,0 104,0 25,0 46376 46510 depths of cut
Refer to page 47 for speed & feed recommendations • Recommended for
TITANIUM materials ≤ 45 HRc
(≤ 420 Bhn)
HARDENED STEELS

For patent
information visit
www.ksptpatents.com


53
END MILLS
www.kyocera-sgstool.com END MILLS