Общий каталог Osawa 2021 - страница 405
Навигация
Общий каталог Osawa 2018
HF UNI - Variable Helix and unequal pitch - Corner radius
CUTTING PARAMETERS
INFO
HF842
Material Group P1 P2 P7 K1 P3 P4 M1 K2 K3 P5 M2 M3 K4 S1 S4 S2 S3 S5
ISO 513
| Hardness/Rm | ≤700 N/mm² | 600÷1000 N/mm² | ≤35 HRC | ≤40 HRC | |||
| ap x ae | 2D x 0.2D | 2D x 0.1D | 1.5D x 0.1D | 1.5D x 0.1D | |||
| Vc (m/min) | 190÷230 | 130÷150 | 100÷120 | 50÷70 |
CARBIDE
D fz fz fz fz
DRILLS
| (mm) | (mm/z) | (mm/z) | (mm/z) | (mm/z) |
| 3 | 0.035 | 0.032 | 0.028 | 0.039 |
PU-HPU
4 0.046 0.042 0.037 0.051
TA-4HTA TROCHOIDAL
5 0.058 0.052 0.046 0.063
SUH
| ALH | 6 | 0.068 | 0.061 | 0.054 | 0.074 | |
| HRC | 8 | 0.088 | 0.079 | 0.070 | 0.096 | |
| SUH MINI | 10 | 0.105 | 0.095 | 0.084 | 0.116 | |
| HL | 12 | 0.120 | 0.108 | 0.096 | 0.132 | |
| HSD | 14 | 0.135 | 0.122 | 0.108 | 0.149 | |
| C-SD-TA | 16 | 0.150 | 0.135 | 0.120 | 0.165 | |
| 18 | 0.165 | 0.149 | 0.132 | 0.182 | ||
| 20 | 0.183 | 0.164 | 0.146 | 0.201 |
ap x ae ≤ D5 1.5D x 0.1D 1.5D x 0.1D
NOTES: Down milling CNC programming is required. “ae” value max 0.2xD - “T” value max 0.1xD. The use of end mill with diameter 30-40% smaller than the width of the slot is recommended. HSS The cutting conditions are based on CNC programming with medium dynamic speed. DRILLS With lower CNC dynamic speed, use the same cutting conditions or reduce the cutting speed Vc. With higher CNC dynamic speed, reduce the “T” value by approximately -30 -50% and apply the maximum available cutting speed Vc. LFTA R1 Cutter radius SUTA ae R2 Half of slot width HSS-HSS/CO T Programming width of cut ae Actual width of cut
CARBIDE END-MILLS
G2 MDTA HF VH/UP MEF ALU MEX/MH UH/MH
T
Y (+) Y X (+)
HSS END-MILLS
CARBIDE BURRS
PARAMETERS SUGGESTED WITH HIGH POWER MILLING CHUCK AND STABLE MACHINING CONDITION