Общий каталог Osawa 2021 - страница 398
Навигация
Общий каталог Osawa 2018
HF UNI - Variable Helix and unequal pitch - 45° chamfer
CUTTING PARAMETERS
HF445
Material Group P1 P2 P7 K1 P3 P4 M1 K2 K3 P5 M2 M3 K4 S1 S4 S2 S3 S5
ISO 513
| Hardness/Rm | ≤700 N/mm² | 600÷1000 N/mm² | ≤35 HRC | ≤40 HRC | |||
| ap x ae | 2D x 0.2D | 2D x 0.1D | 1.5D x 0.1D | 1.5D x 0.1D | |||
| Vc (m/min) | 160÷200 | 110÷130 | 80÷100 | 50÷70 |
| D | fz | fz | fz | fz |
| (mm) | (mm/z) | (mm/z) | (mm/z) | (mm/z) |
TROCHOIDAL
| 6 | 0.066 | 0.059 | 0.052 | 0.072 |
| 8 | 0.085 | 0.077 | 0.068 | 0.094 |
| 10 | 0.102 | 0.092 | 0.082 | 0.112 |
| 12 | 0.117 | 0.105 | 0.093 | 0.128 |
| 14 | 0.131 | 0.118 | 0.105 | 0.144 |
| 16 | 0.146 | 0.131 | 0.117 | 0.160 |
| 20 | 0.177 | 0.160 | 0.142 | 0.195 |
NOTES: Down milling CNC programming is required. “ae” value max 0.2xD - “T” value max 0.1xD. The use of end mill with diameter 30-40% smaller than the width of the slot is recommended. The cutting conditions are based on CNC programming with medium dynamic speed. With lower CNC dynamic speed, use the same cutting conditions or reduce the cutting speed Vc. With higher CNC dynamic speed, reduce the “T” value by approximately -30 -50% and apply the maximum available cutting speed Vc. R1 Cutter radius ae R2 Half of slot width T Programming width of cut ae Actual width of cut
Y (+) Y X (+)
T
INFO
CARBIDE DRILLS
PU-HPU TA-4HTA SUH ALH HRC SUH MINI HL HSD C-SD-TA
HSS DRILLS
LFTA SUTA HSS-HSS/CO
CARBIDE END-MILLS
G2 MDTA HF VH/UP MEF ALU MEX/MH UH/MH
HSS END-MILLS
PARAMETERS SUGGESTED WITH HIGH PRECISION WELDON CHUCK AND STABLE MACHINING CONDITION. FOR APPLICATION ON HIGH POWER MILLING CHUCK, PLEASE REFER TO HF444 PARAMETERS.
CARBIDE BURRS