Каталог Iscar дисковые фрезы и фрезерные пластины 2022 - страница 42

Предыдущая страница Следующая страница

Навигация

Inserts LNHT 1106...HT inserts should be used if a straight groove or shoulder are needed. When using the other inserts, the machined surface is grooved due to the butterfly insert shape. Side Wall Flatness Depending on the Inserts Being Used

DesignationNumber of Side Flatness Side Flatness Half Side Tools Axial
Cutting Edgesap5 H (mm)a =10 H (mm)ApplicationDepth of Cut a (mm)

p p

LNKX 1106...4R+4LFlat0.45Double Face MIllingStock=0-10
LNMT 1106...4R+4LFlat0.45Stock=0-10

ap ap

LNHT 1106 - N(1)2R+2LFlatFlatStock=0-10
LNKX 1106...4RFlat0.45Half side MillingStock=0-10
LNMT 1106...4RFlat0.45Stock=0-10

ap

LNHT 1106 - R(2)4RFlatFlatStock=0-10
LNKX 1106...4LFlat0.45Half side millingStock=0-10
LNMT 1106...4LFlat0.45Stock=0-10

ap

LNHT 1106 - N(1) 2L Flat Flat Stock=0-10

(1) Use of 8 cutting edges (4R+4L) is possible only when a ≤5 mm, otherwise 4 cutting p edges (2R+2L) can be used

ap-7 7 ap Configuration Guide for Full Slot FDN/SDN... CALN11 Cutters

Number Bottom Slot Half Side Tools
Designationof Cutting Flatness Insert Radius Axial Depth of
EdgesH (mm)R (mm)ApplicationCut W (mm)

LNHT 1106...

2R+2L 0.45 0.8 W=14-19.5

LNKX 1106...

LNMT 1106... 2R+2L 0.45 0.8 W=14-19.5

W

LNHT 1106 - N(1) 2R+2L Flat 0.8 W=14-19.5

WÊ-Ê11.0 W

R H

LNHT1106... - NLNKX 1106...(LNHT 1106... - R
R.H./L.H.LNMT 1106...R.H. only

R.H./L.H.

Page 482 Page 481 Page 481