Каталог Iscar дисковые фрезы и фрезерные пластины 2022 - страница 205

MILLING INSERTS
RE ...CS
S1
FF WOCT/WOMT/WOMW IC
Arc Cutting Edge Inserts L Rd°
for Fast Feed Machining INSBD
at Small Depths of Cut
S APMX

Recommended
Dimensions Tough 1 Hard
Machining Data

ap fz


IC882
IC328
IC928
IC908
IC910
Designation IC L S S1 INSBD RE Rg(3) APMX (mm) (mm/t)
FF WOCT 060212T 9.86 7.00 2.70 4.20 5.60 2.00 3.00 1.00 • • • 0.30-1.00 0.30-1.00
FF WOMT 060212T-M 9.86 7.00 2.70 4.20 5.60 2.00 3.00 1.00 • • 0.30-1.00 0.70-1.50
FF WOMW 060212T-M (1) 9.86 7.00 2.70 4.70 5.60 2.00 3.00 1.00 • 0.50-1.00 0.50-3.50
FF WOCT 09T320T 14.50 10.60 3.95 6.50 9.30 2.00 4.00 1.50 • • • 0.70-1.50 0.30-1.00
FF WOMT 09T320-CS (2) 14.50 10.60 3.95 6.50 9.30 2.00 4.20 2.00 • 1.50-2.00 0.70-1.20
FF WOMT 09T320T 14.50 10.60 3.95 6.50 9.30 2.00 4.00 1.50 • • • 0.70-1.50 0.70-2.00
FF WOMW 09T320T (1) 14.50 10.60 4.00 6.50 9.30 2.00 4.00 1.50 • 0.80-1.50 0.50-3.50
• For cutting speed recommendations, see pages 542-547
(1) Used for heavy machining, interrupted cuts and for hardened steel.
(2) Chip splitting insert - effective at depths of cut larger than 0.75 mm.
(3) Radius for programming
For tools, see pages: FF EW (304) • FF EW-CF (305) • FF EW-M (305) • FF FW (309)

FF WOMT FF WOCT FF WOMW


For general applications For high temperature alloys For hard material and
and stainless steel interrupted cut


S
FFT3 WXMT 03 IC
Single-Sided Small Trigon Rd°
Inserts for Fast Feed Milling
RE 17˚
APMX

Dimensions Tough 1 Hard Recommended Machining Data
IC5820


ap fz
IC882
IC830


IC808


Designation IC S RE APMX (mm) (mm/t)
FFT3 WXMT 030206T 4.20 2.20 0.60 0.60 • • • • 0.20-0.60 0.20-0.80
• For side plunging, the initial cutting feed is 0.08 mm/t • For cutting speed recommendations, see pages 542-547
For tools, see pages: FFT3 EFM-03 (293) • FFT3 EFM-MM 03 (293)


521