Общий каталог SGS 2021 - страница 128

FRACTIONAL S-Carb APR® Ap Ae Ae DC • inch Series APR-3 43APR-3 Vc Fractional Ae x DC Ap x DC (sfm) 0.75 1 5250 RPM 26740 20055 Slot 1 ≤1 Fz 0.0055 0.0059 (980-6900) Feed (ipm) 441 355 N ALUMINIUM ALLOYS6068, 7075 Profile 5900 RPM 30051 22538≤ 0.5≤ 1.5Fz0.00630.0067(980-6900) Feed (ipm) 568 453 HSM 6900 RPM 35144 26358 ≤ 0.1 ≤2 Fz 0.0075 0.0079 (980-6900) Feed (ipm) 791 625 DC • inch Series APR-3 LONG 43APR-3L Vc Fractional Ae x DC Ap x DC (sfm) 0.5 0.625 0.75 1 3280 RPM 25059 20047 16706 12530 Slot 1 ≤1 Fz 0.0039 0.0043 0.0047 0.0051 (980-6900) Feed (ipm) 293 259 236 192 N ALUMINIUM ALLOYS6068, 7075 Profile 3950 RPM 30178 24142 20119 15089≤ 0.5≤ 1.5Fz0.00470.00510.00550.0059(980-6900) Feed (ipm) 426 369 332 267 HSM 4600 RPM 35144 28115 23429 17572 ≤ 0.1 ≤2 Fz 0.0055 0.0059 0.0063 0.0067 (980-6900) Feed (ipm) 580 498 443 353 RPM stated may be outside of most machine tools in the smaller sizes, adjust the surface speed but maintain the Fz For best results use the peak power of the specific machine torque chart. Typically 10hp is required to remove 45 cubic inches of material (MRR). Eg. >> (Ae x Ap x Feed) >> Therefore Full slotting 1" dia: 1 x 1 x 355 = 355 cubic inches, so it needs a min of 78hp. Larger cuts and chip load consume more power. Review the power chart of each machine to determine MAX power for ultimate performance. Example below shows peak power @ 10,000 rpm. The new coolant supply is designed for MQL as well as normal emulsion coolant on the same data. Ensure max MQL flow prior to cutting. Refer to the SGS Tool Wizard® for complete technical information (www.kyocera-sgstool.com). 128 END MILLS wwwE.kNyDoMceILraLS-sgstool.com 10000 rpm