Общий каталог Widia 2017 - страница 1596

Предыдущая страница Следующая страница

Навигация

T Materialop Cut 4 PocketIn TC TC 12,0sert Size F040203 F040204 0–13,99A AC AP mmRecom In TC TC 14,0mended sert Size F060203 F050204 0–18,99Feed R B BC BP mmate by D In TC TC 19,0iameter sert Size F070304 F070306 0–23,99(mm/r) C CC CP mmIn TC TC 24,sert Size F090305 F080308 00–29,99D DC DP mm
Group ConditionSeatGeometryGrademinStartmaxminStartmaxminStartmaxminStartmax
SP CV36 V36WU40PH WU40PH0,060,080,120,070,100,130,080,100,150,100,120,16
1 UP CV36 V36WU40PH WU40PH0,060,080,120,070,100,120,080,100,140,100,120,15
IP CV36 V36WU40PH WU40PH0,060,080,110,070,100,110,080,100,140,100,120,15
SP CV36 V36WU40PH WU40PH0,060,080,120,070,100,130,080,100,150,100,120,16
M 2 UP CV36 V36WU40PH WU40PH0,060,080,120,070,100,120,080,100,140,100,120,15
IP CV36 V36WU40PH WU40PH0,060,080,110,070,100,110,080,100,140,100,120,15
SP CV36 V36WU40PH WU40PH0,060,080,120,070,100,130,080,100,150,100,120,16
3 UP CV36 V36WU40PH WU40PH0,060,080,120,070,100,120,080,100,140,100,120,15
IP CV36 V36WU40PH WU40PH0,060,080,110,070,100,110,080,100,140,100,120,15

For 5 x D, diameter range 12–23,99mm (insert sizes A to C), it is highly recommended to start with feed and speed values reduced by 20% less than above recommendations. For 5 x D, diameter range 24–68mm (insert sizes D to H), it is highly recommended to start with feed and speed values reduced by 15% less than above recommendations. For 4 x D and 5 x D, it is recommended to reduce the feed rate during entry and exit by 30–50%. Condition: S = stable conditions, U = unstable cutting conditions, I = interrupted cutting conditions Pocket Seat: P = periphery insert, C = centre insert