Каталог Widia достижения 2020 - страница 26

Предыдущая страница Следующая страница

Навигация

High-Feed Mills • VXF-09

Recommended Starting Speeds [m/min]*

Material GroupWP25PMWP40PMWS40PM
1395340325355310295–––
2330290240300260215–––
P 3305260210275235190–––
4270220180245205160–––
5220205180205185160205175145
620015012018014011018013095
1245215200235205185250205170
M 2220190155210180150215175145
3170145115155140110175130100
1504030504035504030
S 2504030504035504030
3605030605035605030
4856040806040706035

NOTE: FIRST choice starting speeds are in bold type. As the average chip thickness increases, the speed should be decreased. *Material groups P, M, K, and H show recommended starting speeds for dry machining. For wet machining, reduce speed by 20%. *Material groups N and S show recommended starting speeds for wet machining. Not recommended for dry machining.

Recommended Starting Feeds [mm]

0,90 Axial DepthofCut (AP1)Lig Machht iningGen Purperal oseHeavy Machining
Insert Geometry5%10%Recomme in Relationded S n to %tarting F of Radial 20%eed per EngageTooth (F ment (aez) ) 30%40–100%Insert Geometry
.E..MM0,481,422,200,351,001,520,260,741,110,230,640,960,210,590,88.E..MM
.S..MH0,701,582,650,501,111,800,370,821,310,330,711,140,300,651,04.S..MH

At 1,10 Axial Depth of Cut (AP1)

Insert Geometry5%R i 10%ecomm n Relatioended S n to %tarting F of Radia 20%eed per l EngageTooth (F ment (aez) ) 30%40–100%Insert Geometry
.E..MM0,441,281,980,320,901,370,240,671,010,210,580,870,190,530,80.E..MM
.S..MH0,641,422,370,451,001,630,340,741,190,300,641,030,270,590,94.S..MH

At 1,50 Axial Depth of Cut (AP1)

Insert Geometry5%R i 10%ecomm n Relatioended Starting F n to % of Radia 20%eed per l EngageTooth (F ment (aez) ) 30%40–100%Insert Geometry
.E..MM0,641,422,370,451,001,630,34 0,741,190,300,641,030,270,590,94.E..MM
.S..MH0,551,222,010,390,861,390,29 0,641,020,250,550,890,230,510,81.S..MH

NOTE: Use “Light Machining” values as starting feed rate.