Каталог Stellram токарный инструмент - страница 19
Навигация
Каталог Stellram материалы и сплавы
Каталог Stellram твердосплавные цельные фрезы
Каталог Stellram фрез со сменными пластинами
Каталог Stellram высокопроизводительные фрезерные системы
Каталог Stellram системы со сменными пластинами для фрезерования с высокими подачами
-15 Geometry Technical Information
Medium to Finishing:
The -15 Geometry is ideally suited to applications which require light
depths of cut and feeds, and where vibration could be an issue. This
geometry is ground and has a sharp edge condition.
Available in Grades: SP4019 & GH1
Materials Application
Cutting Condition
SP4019
P M K N S H
| 4 | 4 | 8 | ||
| GH1 | ||||
| Profile |
P M K N S H
EPEX040204F-15 Aluminium: <16% Si HBN 116Aluminium: <16% Si HBN 116
EPEX1.51-15
inch mm EPEX040204F-15
0.118 3,00
0.100 2,50
0.080 2,00
0.060 1,50 -15
0.040 1,00
0.020 0,50
-61 Inserts
-61 Geometry Technical Information
Finishing:
The -61 Geometry has 6 cutting edges and is one of the most
economical inserts for small part machining. The chip-breaker provides
good chip control and surface finish.
Available in Grade: SP4019
Materials Application
Cutting Condition
SP4019
P M K N S H
4 4 8
Profile
| mm | 0,05 | 0,10 | 0,15 | 0,20 | 0,25 | 0,30 |
| inch | 0.002 | 0.004 | f 0.006 (feed/rev)0.008 | 0.010 | 0.015 |
n f (feed/rev) n
750 - 950 N/mm 2 HBN
WPMT050304E-61Unalloyed Steel: 750 - 950 N/mmUnalloyed Steel: 2 HBN 220 - 270
220 - 270
| inch | WPMT050304E-61 mm |
| 0.118 | 3,00 |
| 0.100 | 2,50 |
| 0.080 | 2,00 |
| 0.060 | 1,50 |
| -61 | |
| 0.040 | 1,00 |
| 0.020 | 0,50 |
| mm | 0,05 | 0,10 | 0,15 | 0,20 | 0,25 | 0,30 |
| inch | 0.002 | 0.004 | 0.006 | 0.008 | 0.010 | 0.015 |
f (feed/rev) n f (feed/rev) n
Material Guide – Key to Recommended Inserts
Material Designation
PP Unalloyed Steels PP Alloyed Steels MM Stainless Steels MM PH Stainless KK Cast Irons NN Aluminum & Alloys SS High Temp. Alloys HH Hard Materials