Общий каталог SGS 2018 - страница 47

FRACTIONAL Z-Carb POS 4 ≠ TOLERANCES (inch) 1/8–1/4 DIAMETER Z1B FRACTIONAL SERIES D1 = +0.0000/–0.0012 D2 = h6 inch EDP NO. • Unequal helix design CUTTING LENGTH OVERALL SHANK Ti-NAMITE-X Ti-NAMITE-X JetStream aids in damaging >1/4–3/8 DIAMETER DIAMETER OF CUT LENGTH DIAMETER (TX) (TX) harmonics by changing D1 = +0.0000/–0.0016 D1 L2 L1 D2 W/FLAT the angle at which each cutting edge enters and D2 = h6 1/8 3/8 1-1/2 1/8 36358 – – exits the material >3/8–1 DIAMETER 5/32 7/16 2 3/16 36357 – – • Unequal flute spacing 3/16 7/16 2 3/16 36359 – – helps to disrupt the D1 = +0.0000/–0.0020 rhythmic pattern D2 = h6 7/32 7/16 2-1/2 1/4 36361 – – created by the cutting edge helping to 1/4 1/2 2-1/2 1/4 36344 – – suppress damaging STEELS 1/4 3/4 2-1/2 1/4 36590 – – harmonics 9/32 5/8 2-1/2 5/16 36353 – – • Optimal material STAINLESS STEELS removal rates through 5/16 13/16 2-1/2 5/16 36345 – – increased feed and CAST IRON depths of cut 11/32 13/16 2-1/2 3/8 36354 – – • Ball nose design ideal HIGH TEMP ALLOYS 3/8 7/8 2-1/2 3/8 36346 36539 – for finishing operations TITANIUM 13/32 15/16 2-3/4 7/16 36355 36540 – in complex workpieces 7/16 1 2-3/4 7/16 36347 36541 – • Recommended for HARDENED STEELS materials ≤ 45 HRc 15/32 1 3 1/2 36356 36542 – (≤ 420 Bhn) 1/2 1 3 1/2 36348 36543 36846 For patent 1/2 1-1/4 3-1/4 1/2 36591 36592 – information visit www.ksptpatents.com 9/16 1-1/8 3-1/2 9/16 36349 36544 36847 5/8 1-1/4 3-1/2 5/8 36350 36545 36848 3/4 1-1/2 4 3/4 36351 36546 36849 1 1-1/2 4 1 36352 36547 36850 47 END MILLS www.kyocera-sgstool.com END MILLS