Общий каталог SGS 2018 - страница 36

FRACTIONAL Z-Carb-AP 4 ≠ ≠ Z1PLC TOLERANCES (inch) 1/4 DIAMETER FRACTIONAL SERIES D1 = +0.0000/–0.0012 inch EDP NO. • Variable rake geometry D2 = h6 alters and controls the CUTTING LENGTH OVERALL SHANK REACH CORNER Ti-NAMITE-X DIAMETER OF CUT LENGTH DIAMETER RADIUS R = +0.0000/–0.0020 cutting dynamic taking chatter suppression to an D1 L2 L1 D2 L3 R >1/4–3/8 DIAMETER unprecedented level 1/4 1/2 2-1/2 1/4 1-1/8 .020 36447 D1 = +0.0000/–0.0016 • Unequal helix design 1/4 1/2 3-1/2 1/4 1-5/8 .020 36448 D2 = h6 changes the cutting 1/4 1/2 4 1/4 1-1/4 .020 36450 angle to improve R = +0.0000/–0.0020 harmonics 1/4 1/2 4 1/4 2-1/8 .020 36449 • Unequal flute spacing 5/16 13/16 3 5/16 1-3/8 .020 36453 >3/8–1 DIAMETER helps to disrupt the 5/16 13/16 4 5/16 2 .020 36454 D1 = +0.0000/–0.0020 rhythmic pattern created D2 = h6 by the cutting edge 5/16 13/16 4 5/16 1-5/8 .020 36452 R = +0.0000/–0.0020 helping to suppress 3/8 7/8 3 3/8 1-5/8 .020 36457 damaging harmonics 3/8 7/8 5 3/8 1-7/8 .020 36456 • Long reach design allows for deeper and faster 3/8 7/8 4 3/8 2-3/8 .020 36458 STEELS cuts 7/16 1 6 7/16 2 .020 36460 STAINLESS STEELS • Enhanced corner 1/2 1 4 1/2 2 .030 36463 geometry with tight CAST IRON tolerance corner radii 1/2 1 5 1/2 3 .030 36464 • Recommended for 1/2 1 6 1/2 2-1/4 .030 36462 HIGH TEMP ALLOYS materials ≤ 45 HRc 9/16 1-1/8 6 9/16 2-1/2 .030 36466 (≤ 420 Bhn) TITANIUM 5/8 1-1/4 5 5/8 2-1/2 .040 36468 5/8 1-1/4 6 5/8 3-3/4 .040 36469 HARDENED STEELS 5/8 1-1/4 6 5/8 3 .040 36470 For patent 3/4 1-1/2 6 3/4 3-1/2 .040 36472 information visit 1 1-1/2 6 1 3 .040 36475 www.ksptpatents.com 1 1-1/2 6 1 4 .040 36474 36 END MILLS END MILLS www.kyocera-sgstool.com