Общий каталог SGS 2018 - страница 125
Навигация
Каталог SGS шестизубые фрезы T-carb
Каталог SGS микро инструмент 2021
Каталог SGS фрезы для алюминия S-carb
Каталог SGS высокопроизводительные черновые фрезы
Каталог SGS инструмент для обработки алюминия
Общий каталог SGS 2015 на русском
| Series 43APF | Ae | Ap Ae | Vc | Diame (in | ter (D1) ch) | |||
| Fractional | Hardness | Ae x D1 | Ap x D1 | (sfm) | 1/2 | 3/4 | ||
| Profile | 2625 | RPM | 20055 | 13370 | ||||
| ≤ 0.1 | ≤ 2.5 | (2100-3150) | Fz | 0.0030 | 0.0050 | |||
| ALUMINUM ALLOyS 2024 5052 5086 6061 | ≤ 150 Bhn | Feed (in/min) | 241 | 267 | ||||
| , , , , 6063, 7075 | or ≤ 7 HRc | Profile | 2625 | RPM | 20055 | 13370 | ||
| ≤ 0.1 | ≤ 4 | (2100-3150) | Fz | 0.0020 | 0.0040 | |||
| N | Feed (in/min) | 160 | 214 | |||||
| Profile | 1970 | RPM | 15051 | 10034 | ||||
| ≤ 0.1 | ≤ 2.5 | 2 | Fz | 0.0030 | 0.0050 | |||
| ALUMINUM ALLOyS (LITHIUM) | ≤ 150 Bhn | (1576-364) | Feed (in/min) | 181 | 201 | |||
| 2090, 2091, 2099, 2195, 2199, 2297, 8090 | or ≤ 7 HRc | Profile | 1970 | RPM | 15051 | 10034 | ||
| ≤ 0.1 | ≤ 4 | (15762364) | Fz | 0.0020 | 0.0040 | |||
| - | Feed (in/min) | 120 | 161 |
Bhn (Brinell) HRc (Rockwell C) surface speed is dependent on machine spindle and fixturing balancing is recommended at ultra high surface speeds tool life may be reduced when machining Lithium Alloys rpm = Vc x 3.82 / D 1 ipm = Fz x 4 x rpm maximum recommended depths shown reduce speed and feed for materials harder than listed finish cuts typically require reduced feed and cutting depths of 0.02 X D maximum 1 ramp angle = 6˚ (feed rate = 50%) plunging not recommended refer to the KYOCERA SGS Tool Wizard® for complete technical information (www.kyocera-sgstool.com)