Общий каталог PRECITOOL - страница 439

Cost reduction

Reduction of expenses through flexibility in your production

Six good reasons to use the Albrecht APC

by up to 1.5 times higher service life of the cutting tool compared to customary shrink chucks. This is due Tool cost to the constructively generated damping and overall savings stiffness, as well as the high balancing quality and the guaranteed concentricity (Data basis: Survey FH Offenburg, Prof. Dr. H. Schönherr).

by an exceptionally high holding torque of the tool. The More safety very large transmission ratio of the integrated worm during cutting gear in conjunction with the small taper angle of the clamping sleeve brings about a holding torque of, e.g., 200 Nm with shank diameter 12 mm.

• no expensive shrink unit has to be purchased; and

More cost-effective idle time during heating and cooling is avoided.

• for other clamping systems an extra clamping chuck

than other must be provided for each tool diameter. The APC clamping systems system offers the possibility to incorporate a wide range of tools and diameters, adapted to current or future production requirements.

A special advantage is the easily accessible opening More accurate and for the included hex wrench. This allows the tool to be faster tool change easily changed even in the machine. Due to the length stop integrated in each clamping sleeve, a µm exact length presetting is possible.

One clamping system Finishing and heavy machining (roughing)

• High speed cutting HSC

for the most varied High performance cutting HPC applications Hard processing

• Drilling, reaming and thread grinding

• Chuck versions with different lengths
• Specially developed for mould making is a long

Universally and slim version applicable Collet chucks for tools with cylinder shank of diameters 3-32 mm

• Taper mounts, optional to DIN 69871, JIS B 6339 (MAS BT), ANSI CAT or DIN 69893 (HSK)