Общий каталог Lamina Technologies 2019 - 2020 - страница 184
Навигация
Общий каталог Lamina Technologies 2017 - 2018
ANVIL CHANGE RECOMMENDATION
As it can be seen on the chart below, some Pitch to Diameter combinations require an anvil As it can be seen on the chart below, most application do not require an anvil change. If change
change. is required, use AE anvils for EX-RH and IN-LH toolholders and AI anvils for IN-RH and EX-LH
If change is required, use AE anvils for EX-RH and IN-LH toolholders and AI anvils for IN-RH and
Pitch Pitch
| TPI | mm | TPI | mm | |||||
| 2.5 | 10 | 2.5 | 10 | (1*) | ||||
| Special | Special | |||||||
| 9 | holders | AE or AI + 4.5° | 9 | holders | AE or AI + 4.5° | (2*) | ||
| required | required | |||||||
| (3*) | ||||||||
| 3 | 8 | 3 | 8 | |||||
| AE or AI + 3.5° | AE or AI + 3.5° | (4*) | ||||||
| 3.5 | 7 | 3.5 | 7 |
AE or AI + 2.5° AE or AI + 2.5° (5*)
| 4 | 6 | Standard anvil (supplied | 4 | 6 | Standard anvil (supplied | (6*) |
| with toolholder) | with toolholder) | |||||
| 5 | 5 | 5 | 5 | (7*) | ||
| 6 | 4 | 6 | 4 | |||
| 3.5 | 3.5 | |||||
| 8 | 3 | 8 | 3 | |||
| 10 | 2.5 | 10 | 2.5 | |||
| Change to anvil AE or 0.5° | ||||||
| 12 | 2 | 12 | 2 | |||
| 16 | 1.5 | 16 | 1.5 |
| mm | 5 | 10 | 20 | 30 | 40 | 50 | 60 | 70 | 80 | 90 | 100 | 110 | 120 | 130 | 140 | |
| inch | 0.25 | 0.50 | 0.75 | 1 | 1.25 | 1.50 | 2 | 2.50 | 3 | 4 | 5 |
| mm | 5 | 10 | 20 | 30 | 40 | 50 | 60 | 70 | 80 | 90 | 100 | 110 | 120 | 130 | 140 | |
| inch | 0.25 | 0.50 | 0.75 | 1 | 1.25 | 1.50 | 2 | 2.50 | 3 | 4 | 5 |
Diameter Diameter (1*) PARTIAL PROFILE 60° TRAPEZ (DIN 103) (2*) PARTIAL PROFILE 55° (3*) ISO
β (4*) UN
(5*) WHIT
(6*) NPT
Ɛ (7*) BSPT Anvil 1.5° Toolholder