Каталог Iscar монолитные сверла 2022

Regrinding Instructions for SCDT	GYRO Auxiliary Devices for Lathe Machines
Pre-Thread Solid Drills
	Designed to Correct Misalignment
For each grinding operation, rotate the drill	on Stationary Operation
180° and repeat the grinding procedure.
	Drills can be used on sloped surfaces up to 6°.
	When drilling sloped surfaces of more than 6°,
	reduce feed by 30-50% during penetration of up
	45° to 5 mm depth, or use a spot or pre-hole drill to
	7°ÊspiralÊrelief avoid drill deviation or poor drill performance.

1 Primary Clearance T.I.R. max. 0.02

a° D Range 7 0.8-6.0 10 >6.1 2 Secondary Clearance

Angular Adj. 1°

Radial Adj. D2.0

3 Chisel

4 Edge Preparation

Grinding Wheel Recommended Specifications: 1 Diameter grinding wheel: GA2 2 Grinding wheel bond: synthetic resin 3 Grit size: 325/400 mesh (45/38µ)

4 Diamond concentration: C-75 (3.3 carat/cm3) 5 Cutting fluid emulsion 3%

Каталог Iscar монолитные сверла 2022 - страница 35