Общий каталог Ingersoll 2011 - страница 1390

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

GENERAL TECHNICAL INFORMATION SET-UP Insert positioning •Cutting edge for drilling should be positioned in the center of tool body Cutting edge for drilling Correct Correct Wrong Coolant pressure • Must be above 20psi, optimal pressure is above 70psi Optimization of chip shape • Material with low carbon content High speed machining is recommended to make the chips thinner as many problems are caused by thick chips •Material with medium to high carbon content If too tight (thick chip?) increase speed if the speed is slow or reduce feed / If too loose (long chip?) reduce speed if the speed is high or increase feed. SET-UP Ø/2 Dia. of center cut-off Please check formation of core and its size after drilling .125" to .250" depth and diameter core should be within .006"-.018" If you are using a clamping unit, adjustment is easy and accurately performed by adjusting the Y-axis of the clamping unit •If a core does not appear It can cause breakage of inserts and vibration when drilling or turning •If the size of core is over the recommendation It will cause overload and vibration 1392