Общий каталог Dijet 2018 - страница 6
Навигация
Общий каталог Dijet 2012 на русском
4. Precaution for using cutting tools
Caution Counter plan
① Misuse or mismatch of working conditions may cause tool 1. Please equip safety items, such as safety glasses and breakage or dispersion of broken pieces. protective gloves. 2. Please use them in the area of our recommended cutting condition (See our catalogue or instruction)
| ② | Excess impact or heavy wear will increase cutting resis- | 1. Please equip safety items, such as safety glasses and |
| tanceand may cause tool breakage and dispersion of | protective gloves. | |
| broken pieces. | 2. Please change tools a bit early for its tool life. | |
| ③ | Lack of dynamic balance in high-speed revolution cause | 1. Please equip safety items, such as safety glasses and |
| vibration and tool-broken. | protective gloves. | |
| 2. Please operate test-run before cutting, and confirm that | ||
| there is no vibration or unusual sound. | ||
| ④ | Sparks, generation of heat or chips in high temperature | Counter plan |
General duringoperation may cause fire. Cutting 1. Please don’t operate around “Danger Zone”, in which area Tools there is some fear of fire or explosion. 2. When oil-coolant is used, please be sure to be enough
system for fire-prevention around there.
Caution Counter plan
| ⑤ | Direct touch to the sharp cutting edge may cause injury. | When you set up them to the machine or take them out of the |
| case, please wear protective gloves. | ||
| ⑥ | Dispersion of hearted or prolonged chips may cause | 1. Please equip safety items, such as safety glasses and |
injury or burn. protective gloves. 2. When you get rid of chips, please stop machining at first, and equip protective items before doing it. ⑦ During cutting operation, cutting tools get very hot. Di-
Please equip safety items, such as safety glasses and recttouch to tools immediately after operation may cause protective gloves. burn.
| ⑧ | Direct contact to the rough surface on the work may | Please don’t touch work materials with bear hands. | ||
| cause inury. | ||||
| Warning | Counter plan | |||
| ⑨ | When inserts or parts are not clamped well, falling off or | 1. Please clean up the insert pocket or fastening parts before |
dispersion may occur and cause injury. setting insert. 2. Please set up the inserts with supplied wrench only, and confirm that the inserts or parts are clamped completely. Indexable ⑩
When indexable tools are used in high-speed revolution Counter plan Cutting orparts may burst out of the body due to centrifugal force. Tools Please use them in the area of our recommended cutting condition. (see our catalogue or instruction)
Counter plan
⑪ When clamped too tight by supplementary tools like pipe etc,inserts or body may be broken. Please set up them with supplied wrench only.