Заказ инструмента: http://steelcam.org 8 (343) 382-52-03 | sales@sverla-ekb.ru Positive Insert Geometries -M Inserts -M Geometry Technical Information VCMT160408E-M SteUenal:llo7y5ed0 S-te9e5l:0 750 - 950 N/mm2 HBN UVCnMaT3l3l2oAy-Med N/mm222H0 -B27N0 220 - 270 Introduction Medium to Finishing: The -M Geometry has a small, well defined chip-breaker for a soft cutting inch mm VCMT160408E-M action, resulting in very little stress being produced, when machining 0.138 3,50 small diameter components. Available in Grades: SP4019 & GH1 0.118 3,00 Materials Application Cutting Condition 0.100 2,50 SP4019 P M K N S H ap (depth of cut)0.0802,00 4 4 8 ap (depth of cut) 0.060 1,50 GH1 Profile P M K N S H 0.040 1,00 -M 0.020 0,50 mm 0,10 0,20 0,30 0,40 0,50 0,60 inch 0.004 0.008 fn 0(f.e01e2d/rev0).016 0.020 0.023 fn (feed/rev) Material Guide – Key to Recommended Inserts Material Designation PP Unalloyed Steels PP Alloyed Steels MM Stainless Steels MM PH Stainless KK Cast Irons NN Aluminum & Alloys SS High Temp. Alloys HH Hard Materials www.kennametal.com C21