Заказ инструмента: http://steelcam.org Positive Insert Geometries 8 (343) 382-52-03 | sales@sverla-ekb.ru -66 Inserts -66 Geometry Technical Information VCGT130304E-66 SteSetali:nle4s5s0Ste-e7l:00 450 - 700 N/mm2 HBN VCSGTt2a.51iAn-6l6ess N/mm2 12H0 B- 18N0 120 - 180 Introduction Medium to Finishing: The -66 Geometry has a precision ground periphery and pressed in chip- inch mm VCGT130304E-66 breaker, with a sharp edge condition, ideally suited for fine chip control 0.118 3,00 when machining medical and small precision components. Available in Grade: GH1 0.100 2,50 Materials Application GH1 Cutting Condition 0.080 2,00 P M K N S H ap (depth of cut)0.0601,50 4 4 8 ap (depth of cut) -66 0.040 1,00 Profile 0.020 0,50 mm 0,00 0,05 0,10 0,15 0,20 0,25 0,30 inch 0.000 0.002 0.004fn (fe0e.0d0/r6ev) 0.008 0.010 0.015 fn (feed/rev) -73 Inserts -73 Geometry Technical Information Alloyed Steel: CCMT120408E-73 900 - 1200 N/mm22 HBN 900 - 1200 N/mm HBN Alloyed Steel: 260 - 340 CCMT432A-73 260 - 340 Medium to Roughing: inch mm CCMT120408E-73 The -73 Geometry is an as pressed geometry, covering a wide range of applications and materials, making it the ideal first choice for most 0.255 6,50 medium to roughing, machining applications. Available in Grades: SP4019, NL300 & NL920 0.235 6,00 0.216 5,50 Materials Application SP4019 Cutting Condition 0.180 4,50 P M K N S H ap (depth of cut)0.1604,00 4 4 4 0.138 3,50 NL300 0.118 3,00 P M K N S H Profile 0.100 2,50 ap (depth of cut) 0.080 2,00 -73 NL920 0.060 1,50 P M K N S H 0.040 1,00 0.020 0,50 mm 0,10 0,20 0,30 0,40 0,50 0,60 inch 0.004fn (0f.e00e8d/r0e.0v1)2 0.016 0.020 0.023 fn (feed/rev) Material Guide – Key to Recommended Inserts Material Designation PP Unalloyed Steels PP Alloyed Steels MM Stainless Steels MM PH Stainless KK Cast Irons NN Aluminum & Alloys SS High Temp. Alloys HH Hard Materials C20 www.kennametal.com