GROOVING / CUTTING OFF Through Coolant Blade Voice of Developer Increased wear resistance due How is it possible to reduce to the use of 2 through coolant heat generation? ejection holes. The 2 coolant holes used in the blade are capable of using high coolant pressures of up 2 through coolant (1000 PSI). This is achieved by using as large holes supply the as possible through coolant hole diameter. coolant to both the The ejection holes are located close to the rake and flank face, cutting edge to improve the cutting edge leading to effective cooling effect and increasing wear resistance. cutting edge cooling and increased wear resistance. Additionally this blade can also be used for both low pressure and high pressure coolant (1000 PSI). Coolant Ports F Flexible set up possible with the use of 6 coolant ports. There are 6 coolant ports designed into the tool block. This makes it easier for the end user to set up the tool block and blade to a configuration that suits their needs. If necessary it is also possible to use coolant hose. The ejection type coolant also improves cutting edge cooling and chip evacuation. Coolant Port Coolant Port Coolant OutletCoolant Port (For Square Shank Adapter) Voice of Developer Possible set up to suit the requirements of the workplace environment. One of the objectives of this product is to respond to the customers complaints that “the product did not fit and could not be used”. Starting with the coolant outlet that prevents leaks even when oil quantity or overhangs change. Everything from the material and the shape of the O-ring, to the length of the hose has been tailored to the effective use in the workplace. F229