Общий каталог Ingersoll 2011 - страница 680

• 0003 Table of Contents
• 0006 End Mills
• 0064 Long Edge
• 0104 0Deg Face Mills
• 0160 Face Mills
• 0202 Slotters
• 0218 Form Mills
• 0236 Profile Mills
• 0302 Milling Tech
• 0384 Solid Carbide
• 0448 Solid Carbide Tech
• 0474 Holemaking & Thread Milling
• 0666 Holemaking & Thread Milling Tech
• 0720 Innofit Top On Toolholders
• 0738 HSK Toolholders
• 0774 CAT Toolholders
• 0796 BT Toolholders
• 0816 Adaptions Accessories
• 0872 Turning Inserts
• 1024 Turning Holders
• 1144 Turning Tech
• 1174 Threading Inserts
• 1242 Threading Holders
• 1256 Threading Tech
• 1268 T-Clamp
• 1344 T-Clamp Tech
• 1376 T-CAP
• 1388 T-CAP Tech
• 1394 Product_Index

CHAMFER RINGS DRILLING AND CHAMFERING IN ONE OPERATION Mounting Instructions: 1 Insert the Chamfer Ring on the drill body and slide to the desired position .(1) 2 Rotate the ring clockwise until the stopper engages the flute edge. 3 Tighten the ring clamp screw according to the maximum tightening torque indicated in the table below. 4 Mount the chamfer insert. (Torque 35 in. lbs.). 5 Mount the Qwik•Twist Drill Point.. (1) Mount the ring on the drill body subject to the limitations shown in the drawing to the right and the position possibilities in the table “Chamfer Ring Position Range” on the next page. Maximum Tightening Torque- Ring Clamp Screw Ring Number Ring Clamp Screw Torque CB100-01 thru CB150-01 SD050-A5 62 in. lbs. CB160-01 thru CB200-01 SD060-20 88 in. lbs. Before drilling insure that: • There exists a very small gap beween the chamfer insert and the drill body, but without contact (i.e., chamfer insert should not be in contact with the drill body). • The cutting edge point (45˚) is aligned with the flute edge. 682