Каталог TooTool техническая информация 1 - страница 12

Auto Tools for Multi Utility A\
Insert Cutting Diameter Dmax KTKFSR /L
For Micro Diameter Cutt- off at Sub Spindle
Fig. 1 Fig. 2
When Using Main Spindle Only Main Spindte

Workpiece max,Dl= Dmax. Even if the K
i II ^
©\
cutting edge runs beyond the center
line, the insert does not contact the
workpiece,since the workpiece falls
off.(The clearance between the insert
and the work is 0.2mm)
? 3EH
When the edge is at the center. When the edge is 1mm beyond the center.
t
lii
I&
Right-hand Shown
L
A n
ef
R-hand Insert for R-hand Toolholder.


i AI n
*7 &
I L
%
When Using Both Main and Sub Spindle
Fig. 3 Fig. 4 3« n KTKFSR/L1010K -12A
KTKFSR/L1010K -16A
only for left shape

t Left-hand shown L-hand Insert for L-hand Toolholder.
Workpiece max, D2 = Dmax (Programmed distance
-
Main Spindle
Sub Spindle
beyond the center) x2 In this case, when the cutting l
dege runs beyond the center line, the insert will \ 1 Designation <DD max*
Dimensions(mm)
Insert
Spare parts
contact the workpiece, since the workpiece does not -
FBEII- H W h il h 13 L S T screw Wrench
fall off. Therefore the programmed distance beyond
KTKFSR/L 1010- K12A 6-12 10 10 10 15 22 26 125 5 6
the center must be considered .
1212-F12A 6-12 12 12 12 22 26 85 5 6 TKFD12R/L M4.5x9 T -15
When the cutting edge is programmed to run 1mm When the cutting edge locates
at the workpiece center.
When the cutting edge exceeds 1mm
over the workpiece. 1212-K12B 6-12 12 12 12 26 26 125 5 6
beyond the center, [D2 = Dmax -lmmx2] (Max. clearance
1010-K16A 14-16 10 10 10 20 22 30 125 5 6
between insert and workpiece is 0.2mm in radius)
1212-F16A 14-16 12 12 12 22 30 85 5 6 TKFD16R/L M4.5 X9 T-15
1212-K16B 14-16 12 12 12 26 30 125 5 6

* Dimension T shows the distance from the Toolholder to the cutting edge.
Cutting diameter ( <j> Dsmax) depends on the insert grooving width.
Only Right-hand is available for 13 dimension.


023 024