Cut-Of f Tools 1.5°WFCutting Force (N) HFStockStock BH 1.5°WF HF 2 BH SEC-Small Diameter Cut-Off Tool Holders SCT Type For Cut-off Cut-off (Carbide Holder/Tool Block Type) SCT Fig 1 Fig 2 Small Diameter Cut-off LF LF LH LH 18 Figure shows right hand (R) tool. F Holder (Right Handed) Parts  Dimensions (mm) Cat. No. Height Width OverallLengthCutting Edge Cutting EdgeDistanceHeightHead Flat Screw WrenchApplicable InsertFig H B LF WF HF LH SCT R1010SCT R1212SCT R1616 ● 10 10 120 10●121212012●161612016101216 151515 CT R05○○○○(-NB)CT R12○○○○(-NB) 11 BFTX0410T8L TRX081 SCT R1010-16 ● 10 10 120 10 10 18 2 SCT R1212-16 ● 12 12 120 12 12 18 CT R16○○○○(-NB) 1 BFTX0410T8L TRX08 SCT R1616-16 ● 16 16 120 16 16 18 1 Holder (Left Handed) Parts  Dimensions (mm) Cat. No. Height Width OverallLengthCutting Edge Cutting EdgeDistanceHeightHead Flat Screw WrenchApplicable InsertFig H B LF WF HF LH SCT L1010SCT L1212SCT L1616 ● 10 10 120 10●121212012●161612016101216 151515 CT L05○○○○(-NB)CT L12○○○○(-NB) 11 BFTX0410T8R TRX081 SCT L1010-16 ● 10 10 120 10 10 18 2 SCT L1212-16 ● 12 12 120 12 12 18 CT L16○○○○(-NB) 1 BFTX0410T8R TRX08 SCT L1616-16 ● 16 16 120 16 16 18 1 Features ● Simple Indexable Inserts ● Design Features New clamping system New screw with wrench hole at New screw clamping system makes it possible to change both ends makes it possible to makes it possible to change corners simply by loosening change inserts from the back comers by simply loosening the screwSharp cutting edge of the vertically the screw from the back mounted 2-corner insert with arc-shaped breaker minimises cutting force with good chip evacuation ● High quality surface finish Excellent chip removal with good surface finish even at the centre of the work material end face. Shank Size ● Long, stable tool life New PVD-coated grade □10/12/16mmAC1030U/AC530U with PVD-coated Maximum Cut-off Dia. provides longer andø5/ø12/ø16stable tool lifeInsert tightening AC1030U/AC530U Width of Cut 0.5/1.0/1.5/2.0mm direction indicator Nose Radius 0.05/0mm Front Cutting Edge Angle: 0°/20° CT Type Inserts SCT Type Holder Performance ● Cutting Force ● Surface Finish Small Pip Large Pip 300 Principal Force Feed Force 200 100 0 SCT Type Competitor's Product SCT Type Competitor's Product Work Material: S45C (ø10mm), Width of Cut: 1.5mm Work Material: SUS430 (ø8mm), Width of Cut: 1.0mm (With Feed Direction) vc=60m/min, f=0.06mm/rev Wet vc=45m/min, f=0.02mm/rev Wet F66